Simulation Study on the Influence of Electric Field of 500 kV Single Circuit Transmission Line on UAV

LIU Pingyuan; YAO Junwen; WU Yansong; MEI Hongwei; WANG Liming

doi:10.13296/j.1001-1609.hva.2024.12.020

您当前的位置：

首页 >

文章列表页 >

Simulation Study on the Influence of Electric Field of 500 kV Single Circuit Transmission Line on UAV

Research & Analysis | 更新时间：2025-04-26

- Simulation Study on the Influence of Electric Field of 500 kV Single Circuit Transmission Line on UAV
- High Voltage Apparatus Vol. 60, Issue 12, Pages: 180-187(2024)
- 作者机构：
  
  1.南方电网通用航空有限公司，广州　 510600
  2.广东电网有限责任公司，广州　 510663
  3.清华大学深圳国际研究生院，广东　深圳　 518055
- 作者简介：
- 基金信息：
  
  Science and Technology Project of China Southern Power Grid Company Limited(GDKJXM20190010;031000KK52190001)
- DOI：10.13296/j.1001-1609.hva.2024.12.020
  CLC：
- Received：09 July 2024，
  
  Revised：20 September 2024，
  
  Published：16 December 2024
- 稿件说明：
移动端阅览
LIU Pingyuan, YAO Junwen, WU Yansong, et al. Simulation Study on the Influence of Electric Field of 500 kV Single Circuit Transmission Line on UAV[J]. High voltage apparatus, 2024, 60(12): 180-187.
DOI：

LIU Pingyuan, YAO Junwen, WU Yansong, et al. Simulation Study on the Influence of Electric Field of 500 kV Single Circuit Transmission Line on UAV[J]. High voltage apparatus, 2024, 60(12): 180-187. DOI： 10.13296/j.1001-1609.hva.2024.12.020.

摘要

随着无人机以及各种控制技术的发展，无人机巡检技术被广泛地应用于电网。目前，无人机在电磁场环境下的避障还存在一些缺陷。为了探讨无人机在巡检时，现场运行输电线路对无人机表面电场的影响，文中通过SolidWorks建立了铁塔、导线、大疆M300RTK无人机、电场传感器等设备的模型，导入有限元仿真计算软件Ansoft Maxwell中开展了整体的电场计算。通过改变电压角度获得了一个最合适电压值作为静电场仿真的运行输电线路设置电压，仿真研究了不同距离条件下，无人机、机翼、传感器位置等对无人机表面电场的影响。获得了不同条件下输电线路对无人机表面场强的影响，仿真研究结果可为现场无人机的巡检策略提供数据参考和理论依据。

Abstract

With the development of unmanned aerial vehicle (UAV) and various control technologies

UAV patrol technology is widely used in the power grid. At present

there are still some shortcomings in the obstacle avoidance of UAV operating in electromagnetic field environment. For studying the influence of the operating transmission line on the surface electric field strength of UAV during patrol inspection

the models of tower

wire

DJI M300RTK UAV

electric field sensor are set up by SolidWorks software

then imported into the finite element simulation calculation software Ansoft Maxwell to perform overall electric filed calculation. One most suitable voltage is obtained by changing the voltage angle as the power transmission line setting voltage of electrostatic field simulation. And the influence on surface electric field of the UAV from such positions as UAV shape

wing

sensor location is simulated and studied in different distance conditions. The influence of power transmission line on UAV surface field strength under different conditions is obtained by simulation and the research results in this paper can provide data reference and theoretical basis for the patrol strategy of UAV at site.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

MEC Service Deployment Mechanism of Transmission Line Based on Solar Energy Harvesting Under Power Internet of Things

Typical Fault Analysis Caused by Shielded Separable Connector

Research on Safety Flight Distance Measurement Method of Unmanned Aerial Vehicle in Extra-high Voltage and Ultra-high Voltage Substation

Research and Design of High Voltage Non-contact AC Electroscope

Electric Field Simulation and Optimization of Composite Bushing and Connecting Copper Bar Area of 40.5 kV Gas-insulated Ring Main Unit

Related Author

YANG Jiuyong

JI Yuejie

CUI Mingshi

LU Xu

CUI Song

LI Xi

WANG Dongfang

MA Yongqiang

Related Institution

Information & Telecommunication Branch Company, East Inner Mongolia Electric Power Co., Ltd.

Key Laboratory of Universal Wireless Communications, Ministry of Education, Beijing University of Posts and Telecommunications

East Inner Mongolia Electric Power Co., Ltd.

Wuzhong Company of State Grid Ningxia Power Co

State Grid Ningxia Electric Power Corporation Research Institute

⁰