Fuse Pressure Measurement Method and Analysis of the Influence of Arc Pressure on Arcing Process

XI Zewen; WU Jin; ZHUANG Jinwu; LIU Luhui; YUAN Zhifang; YUE Haibo

doi:10.13296/j.1001-1609.hva.2026.06.026

您当前的位置：

首页 >

文章列表页 >

Fuse Pressure Measurement Method and Analysis of the Influence of Arc Pressure on Arcing Process

Technical Discussion | 更新时间：2026-06-10

- Fuse Pressure Measurement Method and Analysis of the Influence of Arc Pressure on Arcing Process
- High Voltage Apparatus Vol. 62, Issue 6, Pages: 211-216(2026)
- 作者机构：
  
  海军工程大学电气工程学院，武汉 430033
  海军工程大学电磁能技术全国重点实验室，武汉 430000
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2026.06.026
  CLC：
- Received：11 November 2025，
  
  Revised：2026-02-06，
  
  Published：16 June 2026
- 稿件说明：
移动端阅览
XI Zewen, WU Jin, ZHUANG Jinwu, et al. Fuse Pressure Measurement Method and Analysis of the Influence of Arc Pressure on Arcing Process[J]. High Voltage Apparatus, 2026, 62(6): 211-216.
DOI：

XI Zewen, WU Jin, ZHUANG Jinwu, et al. Fuse Pressure Measurement Method and Analysis of the Influence of Arc Pressure on Arcing Process[J]. High Voltage Apparatus, 2026, 62(6): 211-216. DOI： 10.13296/j.1001-1609.hva.2026.06.026.

摘要

为探究熔断器燃弧过程中电弧压力的变化，文中首先设计了一种熔断器内部压力检测方法，可通过外置支架和压力传感器的配合达到测量内部压力的目的。其次，通过两组对比试验验证了测压方式的准确性和可行性，该测压方法可用于对电弧压力和燃弧过程关系的深入研究。再次，设计4组相同电路参数、不同起弧电流的分断试验，以此模拟不同电弧压力的分断试验，记录试验参数、拟合电弧电导率，分阶段对燃弧过程进行了分析。结果表明，各组试验间电弧压力与燃弧功率呈明显映射关系，电弧压力在各个燃弧阶段中对燃弧过程影响不同，在相同电弧功率密度下，电弧电导率与电弧压力存在比例关系。

Abstract

For exploring the variation of arc pressure durign the arcign process of fuse

a internal pressure detection method for fuse is firstly designed and the internal pressure measurement can be achieved through the coordination of external bracket and pressure sensor. Then

the accuracy and feasibility of the pressure measurement method are verified by two groups of comparative tests. This pressure measurement method can be used to deeply study the relationship between arc pressure and arcing process. After that

four sets of breaking tests with same circuit parameters but different arc ignition currents are designed to simulate the breaking tests with different arc pressures

record the test parameters

fit the arc conductivity

and analyze the arcing process by stages. The results show that there is an obvious mapping relationship between the arc pressure and the arcing power in each test set

and the arc pressure has different effects on the arcing process in each arcing stage. Under the same arc power density

the arc conductivity exhibits propotional relationship the arc pressure.

关键词

Keywords

references

王晨,徐建霖.混合型限流及开断技术发展综述[J].电网技术,2017,41(5):1644-1653.

WANG Chen, XU Jianlin.Review of hybrid current limiting and breaking technology development, power system technology[J]. Power System Technology,2017,41(5):1644-1653.

谢运祥,王季梅.国内外熔断器发展概述[J].低压电器,1991(3):5-9.

XIE Yunxiang, WANG Jimei. Domestic and foreign fuses development overview[J]. Low Voltage Apparatus,1991(3):5-9.

殷铭,何正浩,涂志飞,等.电动汽车直流熔断器的发展与关键问题[J].电器与能效管理技术,2019(22):1-5.

YIN Ming, HE Zhenghao, TU Zhifei, et al. Development and key problems of DC fuse for electric vehicle[J]. Electrical & Energy Management Technology,2019(22):1-5.

张海玉,刘闯,晁勤,等.具有LVRT能力的并网光伏系统继电保护问题研究[J].继电器,2015,43(3):53-60.

ZHANG Haiyu, LIU Chuang, CHAO Qin, et al. Research on relay protection issues of grid-connected photovoltaic system with LVRT ability[J]. Relay,2015,43(3):53-60.

黄鑫健,耿英三,石晓光,等.直流熔断器的研究现状与发展前景[J].电器与能效管理技术,2019(2):1-7.

HUANG Xinjian, GENG Yingsan, SHI Xiaoguang, et al.Research status and development prospect of DC electric fuse[J]. Electrical& Energy Management Technology,2019(2):1-7.

朱俊杰,聂子玲,张银峰,等.一种软硬件协同控制的短路限流保护方法[J].继电器,2015,43(19):49-53.

ZHU Junjie, NIE Ziling, ZHANG Yinfeng, et al. A method of shortcircuit current-limiting with software-hardware coordination control[J]. Relay,2015,43(19):49-53.

毛启东,沈兵,庄劲武,等.直流熔断器低过载电流的开断性能优化及其结构设计[J].高电压技术,2020,46(11):3864-3870.

MAO Qidong, SHEN Bing, ZHUANG Jinwu, et al. Optimization and structure design of low overcurrent interruption performance of DC fuse[J]. High Voltage Engineering,2020,46(11):3864-3870.

刘志远,王彤,孙超,等.石英砂熔断器的弧前时间—电流特性[J].高电压技术,2018,44(2):366-371.

LIU Zhiyuan, WANG Tong, SUN Chao, et al. Pre-arcing time and current characteristics of quartz sand fuse[J]. High Voltage Engineering,2018,44(2):366-371.

SATPATHI K, UKIL A, POU J.Short-circuit fault management in DC electric ship propulsion system:Protection requirements, review of existing technologies and future research trends[J]. IEEE Transactions on Transportation Electrification,2018,4(1):272-291.

PATRICHI Ŝ, PLEŠCA A, NIŢUCĂ C, et al. Thermal modeling and simulations for fast electric fuses[C]//2018 International Conference and Exposition on Electrical and Power Engineering (EPE).Iasi:IEEE,2018:920-923.

GRÄF T.Simulation and verification of thermal modelling to prevent from damages caused by the use of HH fuses[J]. International Transactions on Electrical Energy Systems,2021,31(2):e12560.

尹凡,沈兵,庄劲武,等.直流熔断器并联燃弧不均机理研究及优化设计[J].高电压技术,2022,48(10):3919-3926.

YIN Fan, SHEN Bing, ZHUANG Jinwu, et al. Mechanism and optimal design of uneven arc burninginparallel of DC fuses[J]. High Voltage Engineering,2022,48(10):3919-3926.

王帅,庄劲武,董润鹏,等.基于半经验模型的熔断器燃弧过程计算与分析[J].高电压技术,2020,46(1):319-326.

WANG Shuai, ZHUANG Jinwu, DONG Runpeng, et al. Calcula tion and analysis of arcing process of fuses based on semi-empirical model[J]. High Voltage Engineering,2020,46(1):319-326.

陈搏,庄劲武,肖翼洋,等.基于半经验模型的高压限流熔断器电弧特性的计算与分析[J].高电压技术,2014,40(1):282-287.

CHEN Bo, ZHUANG Jinwu, XIAO Yiyang, et al. Calculation and analysis of high-voltage current-limiting fuse's arc characteristics based on semi-empirical model[J]. High Voltage Engineering, 2014,40(1):282-287.

李枫,庄劲武,江壮贤,等.混合型限流熔断器爆炸活塞式高速开断装置炸药腔室结构分析及优化[J].高电压技术,2017,43 (7):2417-2424.

LI Feng, ZHUANG Jinwu, JIANG Zhuangxian, et al. Structure analysis and optimum design on explosive chamber of explosive piston type high-speed interrupter in hybrid current-limiting fuse[J]. High Voltage Engineering,2017,43(7):2417-2424.

王晨,庄劲武,袁志方,等.新型混合型限流熔断器方案设计及其介质恢复特性研究[J].中国电机工程学报,2013,33(36):148-156.

WANG Chen, ZHUANG Jinwu, YUAN Zhifang, et al. Design and dielectric recovery research of novel hybrid current limiting fuse[J]. Proceedings of the CSEE,2013,33(36):148-156.

李金忠,汪可,任家帆,等.分接开关油室电弧故障压力传播过程研究[J].中国电机工程学报,2022,42(20):7651-7658.

LI Jinzhong, WANG Ke, REN Jiafan, et al. Study on pressure propagation process of arc fault in OLTC oil chamber[J]. Proceedings of the CSEE,2022,42(20):7651-7658.

张继军,张东亮,赵建伟,等.小比距离密闭空腔爆炸爆后气体温度和压力测量技术研究[J].爆炸与冲击,2019,39(2):101-106.

ZHANG Jijun, ZHANG Dongliang, ZHAO Jianwei, et al. Study on measurement of gas temperature and pressure after explosion in closed cavity at small-scaled distance[J]. Explosion and Shock Waves,2019,39(2):101-106.

SAQIB M A, STOKES A D, JAMES B W, et al. Electron temperature and arc diameter in a sand-filled HBC fuse[J]. IEEE Transactions on Plasma Science,2011,39(7):1619-1630.

CHEIM L, ALAN F. Spectroscopic observation of high breaking capacity fuse arcs[J]. IEEE Proceedings. A. Science, Measurement& Technology,1994,141(2):123-128.

ANDRE P, AUBRETON J, BUSSIERE W, et al. Basic data:Composition, thermodynamic properties and transport coefficients applied to fuses[C]//2007 8th International Conference on Electric Fuses and their Applications. France:IEEE,2007:95-100.

席泽文,武瑾,庄劲武,等.直流限流熔断器分断燃弧过程的模型优化与验证[J].中国电机工程学报,2023,43(19):7713-7719.

XI Zewen, WU Jin, ZHUANG Jinwu, et al. Model optimization and verification of current - limiting arcing process of DC fuse[J]. Proceedings of the CSEE,2023,43(19):7713-7719.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Review on Breaking Test Technology of MVDC Circuit Breakers

Study on the Influence of Plant Boundary Topography on the Noise Reduction Effect of Sound Barrier in Substations

Dynamic Modeling and Simulation of Alkaline Water Electrolysis Hydrogen Production System

Simulation Calculation of No-load and Short Arcing Interruption of 550 kV Fast Circuit Breaker

Analysis of Arcing Characteristics During Harmonic Current Switching of Vacuum Type On-load Tap-changer

Related Author

No data

Related Institution

No data

⁰