Optimum Design of a Aqueous-electrolyte Divider

WU Chang-feng; JIANG Quan-xing; HE Peng

您当前的位置：

首页 >

文章列表页 >

Optimum Design of a Aqueous-electrolyte Divider

更新时间：2025-04-26

- Optimum Design of a Aqueous-electrolyte Divider
- High VoltageApparatus Issue 3, Pages: 232-235(2008)
- 作者机构：
  
  1. 东南大学电磁兼容研究室
  2. 东南大学电磁兼容研究室江苏南京210096
- 作者简介：
- 基金信息：
- DOI：
  CLC： TM933.213
- Published：2008
- 稿件说明：
移动端阅览
[1]邬昌峰,蒋全兴,何鹏.电解液分压器的优化设计[J].高压电器,2008(03):232-235.

WU Chang-feng, JIANG Quan-xing, HE Peng. Optimum Design of a Aqueous-electrolyte Divider[J]. High voltageapparatus, 2008, (3): 232-235.
[1]邬昌峰,蒋全兴,何鹏.电解液分压器的优化设计[J].高压电器,2008(03):232-235. DOI：

WU Chang-feng, JIANG Quan-xing, HE Peng. Optimum Design of a Aqueous-electrolyte Divider[J]. High voltageapparatus, 2008, (3): 232-235. DOI：

摘要

为了避免脉冲分压器的杂散参数的影响

笔者采用非线性规划的复合形法对按传输线原理设计的电解液电阻分压器的结构参数进行了优化设计

通过分析优化结果得出:在满足测量精度和耐压的情况下

分压器的尺寸越小越好;该型电阻分压器由于其自身结构的特点

要求硫酸铜液电阻的阻值尽量小;对该型电阻分压器进行优化设计时应综合考虑测量的要求。

Abstract

In order to avoid spurious parameters of pulse divider

an optimum design was performed for the structure parameters of a novel aqueous-electrolyte resistance divider by using the complex method of the nonlinear programming problems. After analyzing the results of the optimum design

the following conclusions can be drawn: firstly

the smaller the dimensions of the divider are

the better its performance can be obtained when the measuring accuracy and withstanding voltage are satisfied; secondly

the resistance of copper sulphate should be as small as possible to match with the structure features of the resistance divider; lastly

the requirements of measurement should be considered in the optimum design.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Design of Resistance Divider Used for High Voltage Fast-response Pulse Measurement

Measurement Limitation and Waveform Analysis in Application of Pulsed Townsend Method at Different Gas Pressures

Optimum Design of a Spring Operating Mechanism for the Vacuum Circuit Breaker in the Viewpoint of Dynamical Coordination

Solid Products Formed on Electrodes in SF₆/CO₂ Sparked Gas Mixture Principle Design of a New High Power and Long Pulse Linear Dummy Load

Investigation of Pressure Measuring Method Using Vacuum Gauge Controlled by Pulse Magnetion without Detachment

Related Author

WU Chang-feng

李彦明

邱毓昌

肖登明

刘昕

谢国辉

王季梅

苑舜

Related Institution

Department of Mechanical Engineering, Southeast University

710049

西安交通大学 200030

西安交通大学

上海交通大学

⁰