Experimental Study on Partial Discharge of the Typical Insulation Damage Needle Model of XLPE Cable

SUN Zhen-quan; ZHAO Xue-feng; LI Ji-sheng; LI Yan-ming

doi:10.13296/j.1001-1609.hva.2010.06.012

您当前的位置：

首页 >

文章列表页 >

Experimental Study on Partial Discharge of the Typical Insulation Damage Needle Model of XLPE Cable

更新时间：2025-04-26

- Experimental Study on Partial Discharge of the Typical Insulation Damage Needle Model of XLPE Cable
- High VoltageApparatus Vol. 46, Issue 6, Pages: 55-59(2010)
- 作者机构：
  
  西安交通大学电气工程学院
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2010.06.012
  CLC： TM855
- Published：2010
- 稿件说明：
移动端阅览
[1]孙振权,赵学风,李继胜,李彦明.交联电缆典型绝缘损伤针刺模型的局部放电试验研究[J].高压电器,2010,46(06):55-59.

SUN Zhen-quan, ZHAO Xue-feng, LI Ji-sheng, et al. Experimental Study on Partial Discharge of the Typical Insulation Damage Needle Model of XLPE Cable[J]. High voltageapparatus, 2010, 46(6): 55-59.
[1]孙振权,赵学风,李继胜,李彦明.交联电缆典型绝缘损伤针刺模型的局部放电试验研究[J].高压电器,2010,46(06):55-59. DOI： 10.13296/j.1001-1609.hva.2010.06.012.

SUN Zhen-quan, ZHAO Xue-feng, LI Ji-sheng, et al. Experimental Study on Partial Discharge of the Typical Insulation Damage Needle Model of XLPE Cable[J]. High voltageapparatus, 2010, 46(6): 55-59. DOI： 10.13296/j.1001-1609.hva.2010.06.012.

摘要

构建了交联电缆施工及运行过程中的典型绝缘损伤模型——针刺模型

设计并制作了衰减振荡波电压发生器

分别测量了针刺模型在交流电压及衰减振荡波电压下的局部放电脉冲

对比分析了针刺模型在振荡电压下的局部放电的一些基本特征

结合IEC 60060-3标准对交联电缆采用衰减振荡波的耐压试验与局放测量的可行性进行了探讨

对现场综合评估交联电缆主绝缘的状态方法进行了实验室内的初步试验研究。

Abstract

A typical insulation damage needle model of XLPE cable during installation and operation is constructed

and a generator of damp oscillation impulse voltage is developed.The PD pulse of the needle model is measured respectively under ac voltage and the damp oscillation impulse voltage.Some fundamental characteristics of the needle model under the damp oscillation impulse voltage and ac voltage are compared and analyzed.The feasibility of adopting damp oscillation impulse voltage in withstanding voltage test and PD measurement for XLPE cable is discussed according to IEC 60600-3.The method of evaluating the insulation state of XLPE cable on-site is investigated preliminarily in laboratory.

关键词

Keywords

references

Views

297

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Research on Application of Microphone-optimized Spiral Arrays-based Acoustic Imaging Devices in Partial Discharge Localization

Study on Fiber Interferometric Partial Discharge Ultrasonic Sensing Method Based on Acoustic-optic Modulation and RF Phase Detection

High-frequency Sensing Technology of Partial Discharge of Switchgear Cabinet for Wind Solar & Energy Storage Stations in Gobi Deserts

Research on Influence of Piezoelectric Material Properties and Element Size on Sensitivity of Piezoelectric Sensor for Partial Discharge Monitoring of Transformer

Influence of Environmental Factors on Insulation Performance of Separable Connector for 12 kV Gas Filling Switchgear Cabinet

Related Author

YUE Song

GAO Fei

HAN Shuai

DONG Haoyuan

LI Jun

LI Xin

LIU Chao

QIAO Hui

Related Institution

Electric Power Research Institute of State Grid Tibet Company

China Electric Power Research Institute Co., Ltd.

Iflytek Co., Ltd.

Electric Power Research Institute, State Grid Hebei Electric Power Co., Ltd.

State Key Laboratory of Alternate Electrical Power System with Renewable Energy Sources, North China Electric Power University

⁰