Error Analysis of Leak Detection Method for SF<sub>6</sub> Electrical Equipmen’s Packaging with Plastic Bags and the Detector’s On-site Calibration

XIN Fu; WU Xue-feng

doi:10.13296/j.1001-1609.hva.2011.06.017

您当前的位置：

首页 >

文章列表页 >

Error Analysis of Leak Detection Method for SF₆ Electrical Equipmen’s Packaging with Plastic Bags and the Detector’s On-site Calibration

更新时间：2025-04-26

- Error Analysis of Leak Detection Method for SF₆ Electrical Equipmen’s Packaging with Plastic Bags and the Detector’s On-site Calibration
- High VoltageApparatus Vol. 47, Issue 6, Pages: 83-86(2011)
- 作者机构：
  
  西安西电开关电气有限公司
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2011.06.017
  CLC： TM595
- Published：2011
- 稿件说明：
移动端阅览
[1]辛夫,吴雪峰.SF_6电气设备塑袋包扎检漏方法误差分析及检漏仪的现场校验[J].高压电器,2011,47(06):83-86.

XIN Fu, WU Xue-feng. Error Analysis of Leak Detection Method for SF₆ Electrical Equipmen’s Packaging with Plastic Bags and the Detector’s On-site Calibration[J]. High voltageapparatus, 2011, 47(6): 83-86.
[1]辛夫,吴雪峰.SF_6电气设备塑袋包扎检漏方法误差分析及检漏仪的现场校验[J].高压电器,2011,47(06):83-86. DOI： 10.13296/j.1001-1609.hva.2011.06.017.

XIN Fu, WU Xue-feng. Error Analysis of Leak Detection Method for SF₆ Electrical Equipmen’s Packaging with Plastic Bags and the Detector’s On-site Calibration[J]. High voltageapparatus, 2011, 47(6): 83-86. DOI： 10.13296/j.1001-1609.hva.2011.06.017.

摘要

工厂内及安装现场检查SF

组合电气设备气体密封性能一般采用塑袋局部封装包扎检漏方法

影响该检漏方法结果的因素较多

环境温度、气压、包扎塑袋体积测估以及检测仪器的误差等均会影响检测结果

按文中讨论的方法加以注意和控制

可将检漏检验误差控制在±50%以内。

Abstract

For inspection of SF

leakage at factory and installation spot

the general method is local packaging with plastic bags for GIS.There’re many factors that can affect the result of this method

for example

environmental temperature

atmosphere pressure

volume of plastic bags estimating and the detector’s error etc. But if the inspector paid attention to the problems and controlled according to the method of this essay

then the error of the leakage inspection can be controlled within±50%or less.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Why Do Negative Readings Appear When Measuring the Dielectric Loss of the Potential Transformer and the Capacitive Bushing

Simulation and Analysis on Error of Protective Type CT due to Residual Magnetism

Research on Medium-voltage Electronic Transformers

Improvement Method of Measuring and Tuning of Automatic Arc-suppression Coil

Error Sources of Grounding Grid Resistance Measurement Using Overhead Ground Line

Related Author

QIN Han-min

LI Xiang-yang2

KONG Xiang-jun2

XU Guo-zheng1

GUAN Yong-gan1

QIAN Jia-li1

WANG Peng

WANG Qiang

Related Institution

Zhaoqing Gaoyao Power Supply Branch, Guangdong Guang-dian Power Grid Group Co., Ltd., Gaoyao

Tsinghua University

Chinese ERRI HV Switchgear Institute

中国电力科学研究院高压开关研究所北京100084

北京100085

⁰

Error Analysis of Leak Detection Method for SF6 Electrical Equipmen’s Packaging with Plastic Bags and the Detector’s On-site Calibration

DOI：10.13296/j.1001-1609.hva.2011.06.017

摘要

Abstract

关键词

Keywords

references

Error Analysis of Leak Detection Method for SF₆ Electrical Equipmen’s Packaging with Plastic Bags and the Detector’s On-site Calibration