Research and Application of Medium-frequency Brazing of Cu-W Contact

LIANG Qian

doi:10.13296/j.1001-1609.hva.2012.07.001

您当前的位置：

首页 >

文章列表页 >

Research and Application of Medium-frequency Brazing of Cu-W Contact

更新时间：2025-04-26

- Research and Application of Medium-frequency Brazing of Cu-W Contact
- High VoltageApparatus Vol. 48, Issue 7, Pages: 8-10(2012)
- 作者机构：
  
  西安高压开关有限责任公司
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2012.07.001
  CLC： TG454
- Published：2012
- 稿件说明：
移动端阅览
[1]梁谦.铜钨触头中频钎焊研究与应用[J].高压电器,2012,48(07):8-10.

LIANG Qian. Research and Application of Medium-frequency Brazing of Cu-W Contact[J]. High VoltageApparatus, 2012, 48(7): 8-10.
[1]梁谦.铜钨触头中频钎焊研究与应用[J].高压电器,2012,48(07):8-10. DOI： 10.13296/j.1001-1609.hva.2012.07.001.

LIANG Qian. Research and Application of Medium-frequency Brazing of Cu-W Contact[J]. High VoltageApparatus, 2012, 48(7): 8-10. DOI： 10.13296/j.1001-1609.hva.2012.07.001.

摘要

触头元件由紫铜（铬铜）与（CuW70）组成

在开关设备中起着关键作用

承受高温、高压、耐磨

并有一定的强度要求（冲击）

其焊接质量的好坏直接关系到开关产品质量的优劣。笔者单位对触头焊接多采用火焰钎焊

效率低

合格率低

严重地制约着生产。为了解决这个难题

笔者通过大量工艺试验和详细论证认为

高速局部加热

氧化少、硬度降低小

效率高的中频感应加热是触头焊接的最有效的方法。

Abstract

Contact component which is made of red copper and CuW70

plays an important role in switchgear applications.It withstands high temperature

high voltage

wear resistance and certain strength.The quality of products is directly determined by the welding state.In the past

our company used flame brazing in contact welding

low efficiency

low passing rate

seriously restricted the production.In order to settling this problem

we demonstrates that medium-frequency induction heating with high efficiency is the most useful way for welding of contactors part because heating with high rate could reduce oxidization and increase hardness by experiment and discussion.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

No data

Related Author

No data

Related Institution

No data

⁰