Analysis of an Explosion Accident of 500 kV SF<sub>6</sub> Circuit Breaker

GUO Shu-yong

doi:10.13296/j.1001-1609.hva.2013.02.025

您当前的位置：

首页 >

文章列表页 >

Analysis of an Explosion Accident of 500 kV SF₆ Circuit Breaker

更新时间：2025-04-26

- Analysis of an Explosion Accident of 500 kV SF₆ Circuit Breaker
- High VoltageApparatus Vol. 49, Issue 2, Pages: 135-138(2013)
- 作者机构：
  
  中国南方电网超高压输电公司天生桥局
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2013.02.025
  CLC： TM561.3
- Published：2013
- 稿件说明：
移动端阅览
[1]郭树永.一起500kV SF_6断路器爆炸事故分析[J].高压电器,2013,49(02):135-138.

GUO Shu-yong. Analysis of an Explosion Accident of 500 kV SF₆ Circuit Breaker[J]. High voltageapparatus, 2013, 49(2): 135-138.
[1]郭树永.一起500kV SF_6断路器爆炸事故分析[J].高压电器,2013,49(02):135-138. DOI： 10.13296/j.1001-1609.hva.2013.02.025.

GUO Shu-yong. Analysis of an Explosion Accident of 500 kV SF₆ Circuit Breaker[J]. High voltageapparatus, 2013, 49(2): 135-138. DOI： 10.13296/j.1001-1609.hva.2013.02.025.

摘要

针对兴仁换流站发生的一起500kV SF6断路器爆炸事故

根据SF6断路器的灭弧室结构、开断原理及动作过程

结合现场实际情况

分析了事故的各种可能因素。确定了该起事故的原因为T型机构箱内转轴的轴承漏装

多次分合后转轴逐渐移位

并磨损了传动机构的1个销子

最终导致销子脱落;断路器合闸后弧触头不能接触

出现稳定短电弧导致灭弧室内气体发热

压力升高

灭弧室发生爆炸导致电网短路事故。对制造厂的质量控制提出了建议

以避免类似事故发生。

Abstract

This paper introduced an explosion accident of 500 kV SF6 circuit breaker in Xingren converter station

the structure of breaking unit

theory of interruption and action process about the SF6 circuit breaker was discussed

combining with the practical situation

all possible factors of the accident is analysised.Finally the reasons of the accident were presented:the shafts in the T-mechanism were displaced caused by the two missing bearings after many opening and closing

a pin had sheared off by the excessive forces and finally breaked off from the mechanism;the arcing contacts could not contact after closing operation

a stable short arc was initiated across the arcing contacts

the pressure inside the breaking unit increased for the heated gas.At last

the interrupter exploded and led to a grid short circuit accident.To avoid similar accidents

this paper provided the corresponding proposal about quality control of manufacturers.

关键词

Keywords

references

Views

174

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Acoustic and Vibration Joint Fault Diagnosis Method of High Voltage Circuit Breaker Based on VMD and KFCM-SVM

Research on Influence of Opening Lock System of Spring Mechanism on Opening Time of High Voltage Circuit Breaker

Non-contact Accurate Measurement of Opening Electromagnet Stroke of Spring Operating Mechanism for High Voltage Circuit Breaker

Calculation and Analysis for Electric Field between the Contacts of the Puffer SF₆ Breaker

Analysis for Electric Field of Interrupter in SF₆ Puffer Circuit Breaker

Related Author

HUO Yaojia

WU Yang

CHANG Jing

HAN Li

QIAN Yong

FANG Jizhong

MA Li

DUAN Xiaohui

Related Institution

Ningxia Electric Power Research Institute, State Grid Ningxia Electric Power Company

Pinggao Group Co, Ltd

State Grid Shanxi Electric Power Research Institute

School of Electrical and Control Engineering, Xi'an University of Science and Technology

Shanghai Nyten Electrical Technology Co., Ltd.

⁰

Analysis of an Explosion Accident of 500 kV SF6 Circuit Breaker

DOI：10.13296/j.1001-1609.hva.2013.02.025

摘要

Abstract

关键词

Keywords

references

Analysis of an Explosion Accident of 500 kV SF₆ Circuit Breaker