Development of Electrical-thermal Aging Experimental Setup for Cable Accessories Under High Voltage and Large Current

YOU Shi-yu1; WU Yu-bo1; WAN Li2; ZHOU Kai2; LI Xu-tao2

doi:10.13296/j.1001-1609.hva.2013.07.009

您当前的位置：

首页 >

文章列表页 >

Development of Electrical-thermal Aging Experimental Setup for Cable Accessories Under High Voltage and Large Current

更新时间：2025-04-26

- Development of Electrical-thermal Aging Experimental Setup for Cable Accessories Under High Voltage and Large Current
- High VoltageApparatus Vol. 49, Issue 7, Pages: 29-34(2013)
- 作者机构：
  
  1. 四川省电力公司阿坝公司
  2. 四川大学电气信息学院
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2013.07.009
  CLC： TM832
- Published：2013
- 稿件说明：
移动端阅览
[1]游世宇,吴雨波,万利,周凯,李旭涛.高压大电流下电缆附件电热老化实验装置的研制[J].高压电器,2013,49(07):29-34.

YOU Shi-yu1, WU Yu-bo1, WAN Li2, et al. Development of Electrical-thermal Aging Experimental Setup for Cable Accessories Under High Voltage and Large Current[J]. High voltageapparatus, 2013, 49(7): 29-34.
[1]游世宇,吴雨波,万利,周凯,李旭涛.高压大电流下电缆附件电热老化实验装置的研制[J].高压电器,2013,49(07):29-34. DOI： 10.13296/j.1001-1609.hva.2013.07.009.

YOU Shi-yu1, WU Yu-bo1, WAN Li2, et al. Development of Electrical-thermal Aging Experimental Setup for Cable Accessories Under High Voltage and Large Current[J]. High voltageapparatus, 2013, 49(7): 29-34. DOI： 10.13296/j.1001-1609.hva.2013.07.009.

摘要

电缆附件在运行过程中承受电热的协同作用使其绝缘逐步老化失效

传统的电热老化实验平台无法完全等效电缆附件实际使用过程中的电热协同作用。笔者研制了一种模拟高压大电流条件的电缆附件电热老化装置

装置主体部分由电缆附件及电缆连接组成电流回路

CT（电流互感器）通过电磁感应在回路中耦合产生约250 A的大电流

利用负荷电流的热效应来模拟电缆附件绝缘所承受的热应力作用;同时通过试验变压器施加工频高压到金属回路中

进行电缆附件的电老化。装置搭建完成后

在额定通流条件下进行了工频耐压试验。此外

通过磁场有限元仿真分析了感应电流的产生原理

研究了CT各参数对感应电流大小的影响。该装置为高压大电流下电缆附件的电热老化研究提供了一种新的参考实验方法。

Abstract

Cable accessories are often subjected to the electrical and thermal stresses simultaneously in the operation of power system.Traditional electrical-thermal aging experimental devices cannot well simulate the electrical-thermal cooperative effects.An aging experimental setup under high voltage and high current was designed to simulate the electrical-thermal aging condition of the cable accessory in power system.The current loop of the experimental setup is composed of cable accessories and connection cables.Power frequency high voltage generated by a test transformer is applied to specimens and high current about 250 A generated by CT flows through the loop.Compared with other thermal aging systems

heat of the aging system is originated from heat effect of electric current.A power frequency voltage withstand test was successfully performed for the experimental setup under rated current.Moreover

the magnetic field around CT was analyzed by Finite Element Method（FEM）.Based on the results

theoretical values for the current generated in the loop can be calculated to investigate the relationships between induced current and parameters of CT.The experimental setup provides a new reference method for cable accessories electrical and thermal stress aging.

关键词

Keywords

references

Views

361

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Study on an Electronic Infrared Current Transformer

Design of Zero - sequence Current Transformer with High Performance

光学电流互感器系统的设计

The Calculation of the 3-D Electric Field and Insulation Analysis of the Three Phase in One Tank Type GIS

INVESTIGATION OF RAIN CONTAMINATION FLASHOVER AND APPLICATION OF AIDED SHEDS

Related Author

陈为

张冠生

蔡晓波

Mou Longhua

盛珑

高桦

张国庆

郭志忠

Related Institution

福州大学 350002

福州大学

中国矿业大学

哈尔滨工业大学 150001

哈尔滨工业大学

⁰