Discovery and Analysis of 220 kV GIS Defects

CHENG Shao-wei; JIN Da-xin; LIU Shang-yi; QI Zhuang; QI Ge-qing

doi:10.13296/j.1001-1609.hva.2013.10.024

您当前的位置：

首页 >

文章列表页 >

Discovery and Analysis of 220 kV GIS Defects

更新时间：2025-04-26

- Discovery and Analysis of 220 kV GIS Defects
- High VoltageApparatus Vol. 49, Issue 10, Pages: 141-143+148(2013)
- 作者机构：
  
  大连供电公司
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2013.10.024
  CLC： TM595
- Published：2013
- 稿件说明：
移动端阅览
[1]程绍伟,金大鑫,柳尚一,戚壮,戚革庆.一例220kV GIS缺陷的发现与分析[J].高压电器,2013,49(10):141-143+148.

CHENG Shao-wei, JIN Da-xin, LIU Shang-yi, et al. Discovery and Analysis of 220 kV GIS Defects[J]. High voltageapparatus, 2013, 49(10): 141-143+148.
[1]程绍伟,金大鑫,柳尚一,戚壮,戚革庆.一例220kV GIS缺陷的发现与分析[J].高压电器,2013,49(10):141-143+148. DOI： 10.13296/j.1001-1609.hva.2013.10.024.

CHENG Shao-wei, JIN Da-xin, LIU Shang-yi, et al. Discovery and Analysis of 220 kV GIS Defects[J]. High voltageapparatus, 2013, 49(10): 141-143+148. DOI： 10.13296/j.1001-1609.hva.2013.10.024.

摘要

新增的GIS与运行的GIS对接后

如有条件

应新老设备一起进行交流耐压试验

试验中注意区分闪络放电的部分与原因。故障查找时应采用多种试验手段;交流耐压试验是最有效的方法之一

文中即是运行设备故障用交流耐压试验方法查找的。

Abstract

New GIS and operation of GIS docking

if have the condition

should be old and new equipment to communicate with compression experiment

experiment distinguish flash winding and the reasons for the discharge. Failure search should be adopted by different kinds of test means. Exchange pressure test is one of the most effective ways

and this article namely is to run the equipment failure using AC pressure test method of the search.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Test Equipment of UHV Transformer’s AC Withstand Voltage and Partial Discharge Tests

Discharge and Failure Analysis on 220 kV HGIS AC Withstand Voltage Test

Design of Windproof and Anti-corona Conductor for AC Withstand Voltage Test of EHV Electrical Equipment

Analysis on Typical Lightning Failure of 500 kV Double-circuit Straight Angle Tower

Analysis of a Circuit Breaker Inadequate Closing Failure Due to Pin Defect

Related Author

PAN Hua3

ZHOU You-qing2

PENG Chun-yan2

LI Fu-liang1

QIU Xin-yan1

ZHANG Nan

JIN Da-xin

CHENG Shao-wei

Related Institution

Hunan Ultra High Voltage Bureau

College of Electrical and Information Engineering of Hunan University

Hunan Technical College of Water Resources and Hydropower

State Grid Gansu Electric Power Research Institute

School of Electrical and Electronic Engineering, Huazhong University of Science and Technology

⁰