Technical Challenge of Dieletric Tests for Ultra High Voltage Equipment

ZHANG Xiaoyong; WANG Jiansheng; LI Qiang; ZHONG Lei; HAO Yuliang; CHEN Nan

doi:10.13296/j.1001-1609.hva.2014.02.004

您当前的位置：

首页 >

文章列表页 >

Technical Challenge of Dieletric Tests for Ultra High Voltage Equipment

更新时间：2025-04-26

- Technical Challenge of Dieletric Tests for Ultra High Voltage Equipment
- High VoltageApparatus Vol. 50, Issue 2, Pages: 1-5+11(2014)
- 作者机构：
  
  西安高压电器研究院有限责任公司
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2014.02.004
  CLC： TM855.1
- Published：2014
- 稿件说明：
移动端阅览
[1]张小勇,王建生,李强,钟磊,郝宇亮,陈楠.特高压设备绝缘试验所面临的技术挑战[J].高压电器,2014,50(02):1-5+11.

ZHANG Xiaoyong, WANG Jiansheng, LI Qiang, et al. Technical Challenge of Dieletric Tests for Ultra High Voltage Equipment[J]. High voltageapparatus, 2014, 50(2): 1-5+11.
[1]张小勇,王建生,李强,钟磊,郝宇亮,陈楠.特高压设备绝缘试验所面临的技术挑战[J].高压电器,2014,50(02):1-5+11. DOI： 10.13296/j.1001-1609.hva.2014.02.004.

ZHANG Xiaoyong, WANG Jiansheng, LI Qiang, et al. Technical Challenge of Dieletric Tests for Ultra High Voltage Equipment[J]. High voltageapparatus, 2014, 50(2): 1-5+11. DOI： 10.13296/j.1001-1609.hva.2014.02.004.

摘要

因特高压设备的特殊性

其雷电冲击试验、联合电压试验、湿耐受试验以及直流无线电干扰试验在实施过程中面临着巨大的技术挑战。笔者结合标准、实际试验情况以及试验数据

分析了以上4种试验的难点以及所存在的问题

同时针对实际试验中应采取的应对措施或未来标准的修订提出了建议。对雷电冲击试验

应采取过冲阻尼装置解决波前时间和过冲的矛盾

同时对于部分特殊的特高压设备

相关标准应规定其特殊要求;对工频和冲击的联合电压试验

工频侧的电压补偿不可避免

同时应采取特殊分压器测量确定电压跌落值;对湿试验

淋雨量的容差必然会超出标准要求

且雨滴的雾化现象不可避免。未来标准修订时应充分考虑此情况

对直流无线电干扰试验

因直流电晕特性和交流有本质区别。建议采用测量直流电晕起始和熄灭电压或者用交流法替代测量。

Abstract

Due to the specificity of UHV equipment

some dielectric tests are facing the severe technical challenges

including the lightning impulse voltage test

combined voltage tests

wet tests and DC radio interference voltage tests.In this paper

based on the related standards

actual tests and the test data

the difficulty of the above tests duty is studied and analyzed.In addition

the possible solution is given or the advices for the revise of the standards in the future is presented.For lightning impulse test

the damping device should be used to solve the conflict between overshoot and front time.In addition

the related standards should give the specification for front time or overshoot for UHV equipment more clearly.For power frequency and lightning impulse combined voltage tests

the power frequency voltage compensation is inevitably and the special divider is necessary for the determination of the voltage drop.For wet test

the rainfall will exceed the requirements of standard and the rain fog will occur.The standard revision should take into account it in the future.For DC radio interference test

due to DC corona characteristic is largely different from AC

it is suggested that the DC corona inception & extinction voltage measurement or radio interference measurement under substituted AC voltage.

关键词

Keywords

references

Views

155

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Experimental Study on VFTO Suppression Performance of Magnetic Ring Damping Bus for UHV GIS

Research Review on Tri-post Insulator for EHV/UHV GIL

The Breakdown Characteristics of SF₆ under Superposed Power-frequence and Impulse Voltage

Experimental Calibration for Impulse Voltage Calibrator.

A Method for Calculating SF₆ Insulating Characteristics under Impulse Voltage

Related Author

MU Shuanglu

WANG Hao

LIU Weidong

LI Zhibing

LI Xinyi

GU Qun

YANG Xilong

CHEN Jing

Related Institution

Tsinghua University

China Electric Power Research Institute Co., Ltd.

Xi'an Xidian Switch Electric Co., Ltd.

College of Electrical and Electronics Engineering, Huazhong University of Science and Technology

Qujing Bureau of EHV Cornpany of China Southern Power Grid Corporation

⁰