Induced Voltage Profile Simulation and Influencing Factors Study for 330 kV OPGW

CHEN Jie; GUO Jie; CUI Longyue; JIAO Lixin

doi:10.13296/j.1001-1609.hva.2014.05.018

您当前的位置：

首页 >

文章列表页 >

Induced Voltage Profile Simulation and Influencing Factors Study for 330 kV OPGW

更新时间：2025-04-26

- Induced Voltage Profile Simulation and Influencing Factors Study for 330 kV OPGW
- High VoltageApparatus Vol. 50, Issue 5, Pages: 93-98(2014)
- 作者机构：
  
  1. 西安交通大学
  2. 中国电力科学研究院
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2014.05.018
  CLC： TM751
- Published：2014
- 稿件说明：
移动端阅览
[1]陈洁,郭洁,崔龙跃,矫立新.330kV OPGW感应电压分布计算和影响因素研究[J].高压电器,2014,50(05):93-98.

CHEN Jie, GUO Jie, CUI Longyue, et al. Induced Voltage Profile Simulation and Influencing Factors Study for 330 kV OPGW[J]. High voltageapparatus, 2014, 50(5): 93-98.
[1]陈洁,郭洁,崔龙跃,矫立新.330kV OPGW感应电压分布计算和影响因素研究[J].高压电器,2014,50(05):93-98. DOI： 10.13296/j.1001-1609.hva.2014.05.018.

CHEN Jie, GUO Jie, CUI Longyue, et al. Induced Voltage Profile Simulation and Influencing Factors Study for 330 kV OPGW[J]. High voltageapparatus, 2014, 50(5): 93-98. DOI： 10.13296/j.1001-1609.hva.2014.05.018.

摘要

330 kV输电线路架空地线采用双地线架设方式

一根为钢绞地线

一根为光纤复合地线。研究表明

地线采用分段绝缘、一点接地时电气性能优于逐塔接地和经火花间隙接地

既限制了地线上的感应电压幅值

也减小了地线感应环流及环流损耗

且具有良好的保护性能。笔者应用电磁暂态计算程序建立330 kV输电线路模型

对OPGW地线感应电压的沿线分布进行研究。研究表明

当地线采用分段绝缘、一点接地的接地方式时

绝缘分段长度越长

绝缘地线绝缘端的感应电压越高;当输电线路采用逆相序反向换位时

OPGW地线感应电压比其他导线排列方式和换位方式下的地线感应电压都小。

Abstract

The 330 kV transmission line employs two overhead ground wires

one is steel hinge wire and the other is optical fiber composite wire. It has been proved that a ground wire adopting the segmented insulation with onepoint earthing mode can achieve better electrical performance than adopting the segmented insulation with one-byone tower earthing mode or through spark-gap earthing mode. The segmented insulation with one-point earthing mode limits the amplitude of induced voltage on ground wire

and reduces the induced current and energy loss

which results in reliable protection performance. In this paper

a model of 330 kV transmission line is set up by making use of EMTP to investigate the induced voltage profile on OPGW. The results show that when the segmented insulation with one-point earthing mode is employed

the longer the segmented length is

the higher the induced voltage becomes. When the transmission line adopts the mode of reverse phase order disposition and reverse transposition

OPGW gets the lowest induced voltage compared with other disposition and transposition modes of conductors.

关键词

Keywords

references

Views

160

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Comparison of Induced Charges with Different Grounding Methods of 500 kV Ground Wires

Calculation and Measurement Analysis for Induced Voltage and Current of 500 kV/220 kV Mixed-voltage and Four-circuit Transmission Lines on the Same Tower

Analysis on Influence of Different Aluminum Sheath Structure on Electrical Characteristics of Cable

Development and Project Application of Live Ice-melting System for UHVDC Transmission Lines

Characterization of Short-circuit Fault Voltage Distribution on Load Side of Cable-GIL Hybrid System

Related Author

MA Ye

GONG Jiangang

GUO Jie

FANG Yuqun

CHEN Shu

XU Dangguo

HUANG Shiyang

NING Linru

Related Institution

Jinhua Power Supply Company,State Grid Zhejiang Electric Power Company

Economic Research Institute,State Grid Zhejiang Electric Power Company

School of Electrical Engineering, Xi’an Jiaotong University

Beijing Power Transmission and Transformation Co., Ltd.

State Grid Jibei Electric Power Co., Ltd.

⁰