Preliminary Study on Spectrometric Method for Measuring Furfural Content in Transformer Oil

ZHANG Yuxiao; LI Shengli; YU Peiyuan; LI Ting; WANG Zhongqiang

doi:10.13296/j.1001-1609.hva.2014.08.016

您当前的位置：

首页 >

文章列表页 >

Preliminary Study on Spectrometric Method for Measuring Furfural Content in Transformer Oil

更新时间：2025-04-26

- Preliminary Study on Spectrometric Method for Measuring Furfural Content in Transformer Oil
- High VoltageApparatus Vol. 50, Issue 8, Pages: 47-52(2014)
- 作者机构：
  
  1. 国网河南省电力公司电力科学研院
  2. 华中科技大学环境科学与工程学院
  3. 国网河南省电力公司
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2014.08.016
  CLC： TM855
- Published：2014
- 稿件说明：
移动端阅览
[1]张欲晓,李胜利,喻培元,李婷,王忠强.一种光谱法检测油中糠醛的初步研究[J].高压电器,2014,50(08):47-52.

ZHANG Yuxiao, LI Shengli, YU Peiyuan, et al. Preliminary Study on Spectrometric Method for Measuring Furfural Content in Transformer Oil[J]. High voltageapparatus, 2014, 50(8): 47-52.
[1]张欲晓,李胜利,喻培元,李婷,王忠强.一种光谱法检测油中糠醛的初步研究[J].高压电器,2014,50(08):47-52. DOI： 10.13296/j.1001-1609.hva.2014.08.016.

ZHANG Yuxiao, LI Shengli, YU Peiyuan, et al. Preliminary Study on Spectrometric Method for Measuring Furfural Content in Transformer Oil[J]. High voltageapparatus, 2014, 50(8): 47-52. DOI： 10.13296/j.1001-1609.hva.2014.08.016.

摘要

检测变压器油中糠醛含量是判断变压器绝缘纸老化程度的有效方法。目前常用的高效液相法存在测量过程复杂、花费时间长等缺点。笔者提出一种基于光谱分析技术的简单、快捷的检测方法。研究中发现

当用光谱仪分别直接检测油样和油样萃取液

因油中BHT（抗氧剂264）的干扰

检测结果不佳。加入TBA（2-硫代巴比妥酸）作为显色剂后能排除干扰。在390 nm波长处对糠醛进行了定量分析

测定结果表明

油中的糠醛质量分数在0.10

6.00 mg/L范围内与其吸光度值呈现良好的线性关系。测定精度RSD为1.47%（n=8）

重现性良好

回收率接近100%。

Abstract

Determination of furfural content in transformer oil is an effective method to judge the aging degree of insulated paper in transformer. Currently

the most popular method to measure the content of furfural in transformer oil is HPLC（high performance liquid chromatography）. However the measuring process of HPLC is complex and time-consuming. The present paper reports a rapid method for the determination of furfural based on spectroscopy. It is found during the research that when testing the oil sample and oil sample extraction directly by busing spectrograph

the results are affected by BHT（butylated hydroxytoluene） in samples. Nevertheless

the influence resulting from BHT could be eliminated by adding TBA（2-Thiobar

bituric acid） as chromogenic agent. The absorbance of furfural at 390 nm is analyzed. The results show that a favorable linear relationship between the absorbance and the concentration of furfural can be obtained with good reproducibility when the concentration of furfural is within the range of 0.10

6.00 mg/L and the precision of method was1.47%（n=8）; the recovery rate was around 100%。

关键词

Keywords

references

Views

147

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Propagation Mode Classification for Streamers in Transformer Oil Based on Luminous and Structural Characteristics of Discharge Channels

Research on Adsorption Mechanism of Mn-doped SnS Two-dimensional Materials Towards Dissolved Gases Analysis in Transformer Oil

Experimental Study on Dielectric Surface Flashover under Nanosecond Pulse in Transformer Oil

Study on the Thermal Aging of High Voltage Oil-filled Cable Insulation by Infrared Spectral Analysis

Reason and Treatment of Transformer Oil Filter Fault

Related Author

LU Wu

PENG Zhiyan

ZHAO Wenbin

WANG Zheming

JIA Chenglong

ZENG Linping

LI Xin

CHENG Cheng

Related Institution

School of Electric Engineering, Shanghai University of Electric Power

State Grid Shaanxi Electric Power Company Limited

Northwest Branch of State Grid Corporation of China

北京100080中国科学院研究生院

Graduate School,Chinese Academy of Science

⁰