Design of Experimental Apparatus for Dielectric Surface Flashover Under DC and Pulsed Voltage

CAI Xinjing; CHEN Chengwei; WANG Xinxin; ZOU Xiaobing

doi:10.13296/j.1001-1609.hva.2015.05.007

您当前的位置：

首页 >

文章列表页 >

Design of Experimental Apparatus for Dielectric Surface Flashover Under DC and Pulsed Voltage

更新时间：2025-04-26

- Design of Experimental Apparatus for Dielectric Surface Flashover Under DC and Pulsed Voltage
- High VoltageApparatus Vol. 51, Issue 5, Pages: 35-39(2015)
- 作者机构：
  
  1. 东北电力大学电气工程学院
  2. 清华大学电机系
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2015.05.007
  CLC： TM216;TM507
- Published：2015
- 稿件说明：
移动端阅览
[1]蔡新景,陈承伟,王新新,邹晓兵.直流和脉冲电压下绝缘沿面闪络试验系统的研制[J].高压电器,2015,51(05):35-39.

CAI Xinjing, CHEN Chengwei, WANG Xinxin, et al. Design of Experimental Apparatus for Dielectric Surface Flashover Under DC and Pulsed Voltage[J]. High voltageapparatus, 2015, 51(5): 35-39.
[1]蔡新景,陈承伟,王新新,邹晓兵.直流和脉冲电压下绝缘沿面闪络试验系统的研制[J].高压电器,2015,51(05):35-39. DOI： 10.13296/j.1001-1609.hva.2015.05.007.

CAI Xinjing, CHEN Chengwei, WANG Xinxin, et al. Design of Experimental Apparatus for Dielectric Surface Flashover Under DC and Pulsed Voltage[J]. High voltageapparatus, 2015, 51(5): 35-39. DOI： 10.13296/j.1001-1609.hva.2015.05.007.

摘要

为了研究大气压下绝缘沿面闪络机理

研制了一套直流和脉冲电压下绝缘沿面闪络试验系统。由于沿面闪络是ns时间分辨的动态变化过程

为了使测量的暂态信号是由沿面闪络本身产生

此系统经过特殊设计

主要包括:放电室和同轴电缆采用同轴几何结构连接

阻抗匹配;电源和同轴电缆阻抗匹配。该系统放电室内外导体半径为3.6 cm和8.3 cm

施加的直流电压为±80 kV

施加的脉冲电压幅值为460 kV

上升时间为36 ns。研制的试验系统能满足4 cm间隙沿面闪络试验要求。

Abstract

To study the mechanism of dielectric surface flashover under atmospheric pressure

an experimental apparatus for dielectric surface flashover under DC and pulsed voltage was designed. Because the surface flashover is a nanosecond-scale dynamical process

the experimental apparatus was specially designed to ensure that the measured transient signals are generated by the flashover itself. The discharging chamber is connected with coaxial cable via coaxial geometry with matched impedance

and the impedance of the power supply is matched with that of the coaxial cable. The radii of inner and outer conductors are 3.6 cm and 8.3 cm

respectively. The applied DC voltage is ±80 kV

and the amplitude of the applied pulsed voltage is 460 kV with a rise time of 36 ns. This experimental apparatus meets the requirements for the test of surface flashover across 4 cm gap.

关键词

Keywords

references

Views

210

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Design of Self-integrating Capacitive Voltage Divider for Ferrite Transmission Line Voltage Measurement

Research on Influence of Temperature on Surface Flashover Characteristics of Epoxy Resin

Thermal Aging Characteristics Analysis of HTV Silicone Rubber Composite Insulator Shed

ANALYSIS OF THE SURFACE FLASHOVER ON GIS BASIN INSULATOR UNDER LIGHTNING IMPULSE VOLTAGE

Electric Field Analysis of Typical Surface Insulation Configurations in Vacuum

Related Author

PENG Xiaoling

JIANG Mingyue

WEI Biyang

CUI qiuju

JIANG Jinbo

CHEN Guifeng

LI Xiufen

HUANG Meng

Related Institution

College of Engineering and New Energy, Three Gorges University

State Grid Hubei Electric Power Co., Ltd.

State Key Laboratory of Alternate Electrical Power System with Renewable Energy Sources, North China Electrical Power University

Electric Power Research Institute of State Grid Ningxia Electric Power Co., Ltd.

China Electric Power Research Institute

⁰