Simulation Analysis of Propagation Characteristics of Electromagnetic Wave in GIS Based on FDTD

LU Junyong; WANG Gang; SI Gangquan; YAO Rui; ZHAO Xiying; ZHANG Ting; SHI Yabin; YE Lianjie

doi:10.13296/j.1001-1609.hva.2015.06.031

您当前的位置：

首页 >

文章列表页 >

Simulation Analysis of Propagation Characteristics of Electromagnetic Wave in GIS Based on FDTD

更新时间：2025-04-26

- Simulation Analysis of Propagation Characteristics of Electromagnetic Wave in GIS Based on FDTD
- High VoltageApparatus Vol. 51, Issue 6, Pages: 178-182+190(2015)
- 作者机构：
  
  1. 西安高压电器研究院有限责任公司
  2. 西安交通大学电气工程学院
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2015.06.031
  CLC： TM595
- Published：2015
- 稿件说明：
移动端阅览
[1]路俊勇,王岗,司刚全,姚锐,赵曦英,张婷,史亚斌,叶连杰.基于FDTD的GIS中电磁波传播特性仿真研究与分析[J].高压电器,2015,51(06):178-182+190.

LU Junyong, WANG Gang, SI Gangquan, et al. Simulation Analysis of Propagation Characteristics of Electromagnetic Wave in GIS Based on FDTD[J]. High voltageapparatus, 2015, 51(6): 178-182+190.
[1]路俊勇,王岗,司刚全,姚锐,赵曦英,张婷,史亚斌,叶连杰.基于FDTD的GIS中电磁波传播特性仿真研究与分析[J].高压电器,2015,51(06):178-182+190. DOI： 10.13296/j.1001-1609.hva.2015.06.031.

LU Junyong, WANG Gang, SI Gangquan, et al. Simulation Analysis of Propagation Characteristics of Electromagnetic Wave in GIS Based on FDTD[J]. High voltageapparatus, 2015, 51(6): 178-182+190. DOI： 10.13296/j.1001-1609.hva.2015.06.031.

摘要

该文采用时域有限差分法研究电磁波信号在GIS中的传播特性

从而为GIS局放超高频在线检测提供借鉴与参考。首先参照GIS实际试验装置进行建模

然后分别研究了激励源脉冲宽度与幅值对电磁波传播的影响、电磁波在GIS筒体内传播的时延特性、GIS结构变化对电磁传播特性的影响。仿真结果表明

电磁波信号幅值与衰减速度与激励源的脉冲宽度与幅值关系密切

利用此特征可以帮助判别局放源的种类和严重程度;电磁波信号在GIS内传播时呈现明显的时延和幅值衰减特性

此特征有利于进行局放源的定位;GIS结构变化对电磁波的幅值及信号特征均有影响

因此应按传播特性选择传感器放置点

以取得更好的检测效果。

Abstract

We use the finite difference time domain method to analyze electromagnetic wave propagation characteristics in GIS for the purpose of the UHF on-line monitoring of partial discharge（PD） in GIS.Firstly

a model for detecting PD signals in GIS is built according to the real experimental device to study the influences of the pulse width and amplitude of excitation source

the time delay characteristic and the GIS structure on the electromagnetic wave propagation. Simulation results show that the amplitude and attenuation speed of electromagnetic wave has close relation with the pulse width and amplitude of the excitation source. This feature can be used to determine PD source type and evaluate PD level. The propagation of UHF electromagnetic wave signal in GIS has the time delay and amplitude attenuation effects

which is beneficial to locating position of PD source. And GIS structure imposes effects on both the amplitude and the signal characteristics of the electromagnetic wave

therefore sensor should be properly placed by considering the propagation characteristics of electromagnetic wave in order to obtain better detection.

关键词

Keywords

references

Views

241

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Study on the Monitoring Technique of Partial Discharge of GIS by UHF Method

Ultrasonic Detection of Partial Discharge on Typical Defects in GIS

Typical Application of UHF Partial Discharge Detection in GIS

Feasibility Analysis of Radiating UHF Verification Signal Through Small Hole in Metal Flange

Extraction and Analysis of Characteristic Spectrum of Partial Discharge in GIS Based on UHF Method

Related Author

ZHANG Xiao-yong1

JIA Shen-li1

WANG Jian-sheng2

YIN Hua1

LI Da-jian1

LIANG Ji-zhong1

BU Ke-wei2

YANG Jing-gang1

Related Institution

School of Electrical Engineering, Xi’an Jiaotong University

Xi’an High Voltage Apparatus Research Institute

Measurement Center of Haidong Supply Company

Hebei Electric Power Research Institute

Hebei Shijiazhuang Power Supply Company

⁰