Insulation Coordination Optimization Design for Low Voltage Ride Through Test Device of 35 kV Grid-connected Photovoltaic System

YANG Bo; WANG Deshun; ZHAO Shanglin; YU Bin; CUI Hongfen

doi:10.13296/j.1001-1609.hva.2015.10.002

您当前的位置：

首页 >

文章列表页 >

Insulation Coordination Optimization Design for Low Voltage Ride Through Test Device of 35 kV Grid-connected Photovoltaic System

更新时间：2025-04-26

- Insulation Coordination Optimization Design for Low Voltage Ride Through Test Device of 35 kV Grid-connected Photovoltaic System
- High VoltageApparatus Vol. 51, Issue 10, Pages: 8-12(2015)
- 作者机构：
  
  中国电力科学研究院
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2015.10.002
  CLC： TM615
- Published：2015
- 稿件说明：
移动端阅览
[1]杨波,王德顺,赵上林,俞斌,崔红芬.35kV并网光伏电站低电压穿越检测装置的绝缘配合优化设计[J].高压电器,2015,51(10):8-12.

YANG Bo, WANG Deshun, ZHAO Shanglin, et al. Insulation Coordination Optimization Design for Low Voltage Ride Through Test Device of 35 kV Grid-connected Photovoltaic System[J]. High voltageapparatus, 2015, 51(10): 8-12.
[1]杨波,王德顺,赵上林,俞斌,崔红芬.35kV并网光伏电站低电压穿越检测装置的绝缘配合优化设计[J].高压电器,2015,51(10):8-12. DOI： 10.13296/j.1001-1609.hva.2015.10.002.

YANG Bo, WANG Deshun, ZHAO Shanglin, et al. Insulation Coordination Optimization Design for Low Voltage Ride Through Test Device of 35 kV Grid-connected Photovoltaic System[J]. High voltageapparatus, 2015, 51(10): 8-12. DOI： 10.13296/j.1001-1609.hva.2015.10.002.

摘要

为了避免35kV并网光伏低穿检测装置在高海拔环境运行过程中发生装置内电抗器抽头对周围零电位或抽头间放电等绝缘击穿事故

文中结合产品设计过程中操作过电压测量实验

利用有限元法对低压穿越检测装置在运行过程中耐受高幅值操作过电压条件下的电场分布进行仿真计算

分析了装置内绝缘薄弱区域并提出优化建议。结果表明:在抽头间安装绝缘挡板、增大抽头处螺母表面积、提高接线铜排的曲率及抽头之间的电气间隙等措施可以使装置内原本畸变电场分布更加均匀

最大场强值降低57.2%。

Abstract

In order to avoid insulation breakdown failure of reactor tap to the surrounding zero potential or between tap in process of 35 kV grid-connected photovoltaic system operation in high altitude environmen

in this paper

combining with operating overvoltage measurement test in process of the production design

the electric distribu-tion in the condition of high amplitude operating overvoltage by finite element method

the insulation weak area in the device is analyzed and the present optimization suggestions are presented. The conclusion is: adding insulation board between wire tap

increasing the surface area of nut

improving curvature of wire tap and the electric clearance can make the electric field which is distorted more even

the max field strength would be reduced by 57.2%.

关键词

Keywords

references

Views

114

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Temperature Rise Calculation and Test of Large Capacity Dry-type Air-core Reactor Under AC and DC Superimposed Current

Effect of Mechanical DC Circuit Breaker Operation Timing Sequence on Operating Overvoltage in Flexible DC Distribution Network

Development and Project Application of Live Ice-melting System for UHVDC Transmission Lines

DESIGN AND RESEARCH OF INSTALLATION DIAMETER OF POST INSULATOR FOR DRY-TYPE AIR-CORE REACTOR

Principle and Analysis on Inter-turn Insulation Detection of Dry-type Air-core Reactor

Related Author

SUN Guohua

ZHANG Meng

XI Jingliang

LIU Chengzhu

XIA Zhihui

LIU Xuefeng

YANG Kun

QIAN Lihong

Related Institution

Beijing Power Equipment Group Co, Ltd

School of Electrical Engineering, Xi'an Jiaotong University

Zhuhai Power Supply Bureau, Guangdong Power Grid Corporation

State Grid Shaanxi Electric Power Co., Ltd.

Electric Power Research Institute of State Grid Shaanxi Electric Power Co., Ltd.

⁰