Study on the Dielectric Loss Test Methods of “Oil-Oil”Bushing Cable Outgoing Line Transformers with High Voltage Line

HAN Xutao; LIU Zehui; LI Junhao

doi:10.13296/j.1001-1609.hva.2016.04.018

您当前的位置：

首页 >

文章列表页 >

Study on the Dielectric Loss Test Methods of “Oil-Oil”Bushing Cable Outgoing Line Transformers with High Voltage Line

更新时间：2025-04-26

- Study on the Dielectric Loss Test Methods of “Oil-Oil”Bushing Cable Outgoing Line Transformers with High Voltage Line
- High VoltageApparatus Vol. 52, Issue 4, Pages: 117-122(2016)
- 作者机构：
  
  西安交通大学电力设备电气绝缘国家重点实验室
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2016.04.018
  CLC： TM406
- Published：2016
- 稿件说明：
移动端阅览
[1]韩旭涛,刘泽辉,李军浩.不拆高压引线下“油—油”套管电缆出线变压器介损试验方法研究[J].高压电器,2016,52(04):117-122.

HAN Xutao, LIU Zehui, LI Junhao. Study on the Dielectric Loss Test Methods of “Oil-Oil”Bushing Cable Outgoing Line Transformers with High Voltage Line[J]. High voltageapparatus, 2016, 52(4): 117-122.
[1]韩旭涛,刘泽辉,李军浩.不拆高压引线下“油—油”套管电缆出线变压器介损试验方法研究[J].高压电器,2016,52(04):117-122. DOI： 10.13296/j.1001-1609.hva.2016.04.018.

HAN Xutao, LIU Zehui, LI Junhao. Study on the Dielectric Loss Test Methods of “Oil-Oil”Bushing Cable Outgoing Line Transformers with High Voltage Line[J]. High voltageapparatus, 2016, 52(4): 117-122. DOI： 10.13296/j.1001-1609.hva.2016.04.018.

摘要

文中主要研究了如何在不拆除高压引线下开展"油—油"套管电缆出线变压器的介损试验。根据相关规程和现场情况

通过绕组中性点加压开展介损试验

并通过建立等效电路对试验结果进行分析。主要得到以下结论:不短接绕组两端开展介损试验时测得的电容值变小

tanδ变大

但变化可忽略不计;反接法测量时

电缆使得电容值变大

tanδ变小

而PT（电压互感器）使得电容值变小

tanδ变大;正接法测量时

可排除电缆和PT的影响

适用于开展不拆高压引线时的变压器介损试验。

Abstract

The method of the dielectric loss test of transformers with "oil-oil"bushing-cable leading-out without disassembling high voltage lead is mainly studied in this paper. According to the related standards and the filed situation

dielectric loss is tested by applying voltage on the neutral point of the high voltage winding. The results are analyzed by building equivalent circuit model. It can be concluded that the measured capacitance is larger and the value of the tanδ is smaller because of there is no short-circuiting connecting between the ends of the winding

but the variation can be ignored. It is also shown that cable leads a lager capacitance and a smaller tanδ

while the PT has the opposite effects when using reverse connection method. When positive connection method is used

the impact of cable and PT is excluded

so this method is more suitable for the dielectric loss test without disassem-bling high voltage lead.

关键词

Keywords

references

Views

165

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Prediction Model for Dissolved Gas in Transformer Oil Based on Policy Gradient Optimization

Research on Hybrid Finite Element Method Based on Triangle Mesh and Its Application in Fluid-heat Coupled Calculation of Transformer

Vibration Sound Power Measurement Method of UHV Transformer Based on Location of Main Vibration Point

Research on Multi-source Information Fusion Fault Diagnosis of Transformer Based on KPCA-SVM

Vibration Characteristic Analysis of Transformer Under Harmonic Current with Different Contents

Related Author

TANG Jian

HOU Huijuan

WANG Shaojing

REN Maoxin

SHENG Gehao

JIANG Xiuchen

LI Hao

LIU Gang

Related Institution

Department of Electrical Engineering, Shanghai Jiao Tong University

State Grid Shanghai Electric Power Research Institute

Hebei Provincial Key Laboratory of Power Transmission Equipment Security Defense, North China Electric Power University

Institute of Electrical Engineering Chinese Academy of Sciences

School of Electronic, Electrical and Communication Engineering University of Chinese Academy of Sciences

⁰