Research on Contacting Fault of GIS Contact Based on Vibration Signal

LI Xiuguang; WU Xutao; ZHU Hongbo; GUO Fei; DING Pei; LIU Shitao; MA Yunlong; HAO Jinpeng

doi:10.13296/j.1001-1609.hva.2016.10.028

您当前的位置：

首页 >

文章列表页 >

Research on Contacting Fault of GIS Contact Based on Vibration Signal

更新时间：2025-04-26

- Research on Contacting Fault of GIS Contact Based on Vibration Signal
- High VoltageApparatus Vol. 52, Issue 10, Pages: 165-169+175(2016)
- 作者机构：
  
  1. 西安交通大学
  2. 国网宁夏电力公司电力科学研究院
  3. 国网宁夏电力公司
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2016.10.028
  CLC： TM595
- Published：2016
- 稿件说明：
移动端阅览
[1]李秀广,吴旭涛,朱洪波,郭飞,丁培,刘世涛,马云龙,郝金鹏.基于振动信号的GIS触头接触异常研究分析[J].高压电器,2016,52(10):165-169+175.

LI Xiuguang, WU Xutao, ZHU Hongbo, et al. Research on Contacting Fault of GIS Contact Based on Vibration Signal[J]. High voltageapparatus, 2016, 52(10): 165-169+175.
[1]李秀广,吴旭涛,朱洪波,郭飞,丁培,刘世涛,马云龙,郝金鹏.基于振动信号的GIS触头接触异常研究分析[J].高压电器,2016,52(10):165-169+175. DOI： 10.13296/j.1001-1609.hva.2016.10.028.

LI Xiuguang, WU Xutao, ZHU Hongbo, et al. Research on Contacting Fault of GIS Contact Based on Vibration Signal[J]. High voltageapparatus, 2016, 52(10): 165-169+175. DOI： 10.13296/j.1001-1609.hva.2016.10.028.

摘要

为研究GIS在开关接触不良状况时振动机械特性

笔者在实验室搭建GIS振动信号测试模型

利用自主开发的诊断测试系统对振动机械特性进行了研究

检测结果发现

当GIS设备振动频率基频为100 Hz

接触不良故障严重时

会出现明显的300 Hz和600 Hz信号。通过现场测试

验证了该方法的有效性。

Abstract

In order to study the mechanical vibration characteristic of GIS with bad contacting

the GIS vibration signal testing model is setup in laboratory. The mechanical vibration characteristic of GIS is researched based on a developed diagnosis system. Test results show that

when the basic vibration frequency is 100 Hz and with very bad contacting of the GIS

300 Hz and 600 Hz signals can be detected. The method is verified its effectiveness by onsite testing.

关键词

Keywords

references

Views

294

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Application of Neural Network Based on Improved Particle Swarm Optimization in the Condition Monitoring of Transformer

Mechanical Fault Diagnosis Technology Research of High-voltage Circuit Breaker Based on the Vibration Signal Characteristic

Design and Development of Condition Monitoring System for Circuit Breaker Based on Vibration Signal

Fault Diagnosis Technology of AC Medium-voltage Vacuum Circuit Breaker Based on Vibration Signal

Research Progress and Prospects on Fault Diagnosis Method for Transformer On-load Tap Changer Based on Vibration Signal

Related Author

JIA Rong1

LI Hong-bin2

KANG Hui-xi2

HONG Gang1

ZHONG Jian-ying

LIU Yang

LIN Xin

GUO Yu-jing

Related Institution

Department of Electrical Engineering,Xi′an University of Technology,Xi′an

Gansu Tou River Hydropower Development Ltd.

Henan Pinggao Electric Co., Ltd.

Electrical Engineering,Shenyang University of Technology

State Key Laboratory of Electrical Insulation and Power Equipment, Xi’an Jiaotong University

⁰