Online Calibration of Inner Capacitive Coupling Sensor for XLPE Cables

WANG Tian; GU Xiao; XU Yang; XIA Rong; SHAO Yingbiao; MA Deying

doi:10.13296/j.1001-1609.hva.2017.06.022

您当前的位置：

首页 >

文章列表页 >

Online Calibration of Inner Capacitive Coupling Sensor for XLPE Cables

更新时间：2025-04-26

- Online Calibration of Inner Capacitive Coupling Sensor for XLPE Cables
- High VoltageApparatus Vol. 53, Issue 6, Pages: 129-134+140(2017)
- 作者机构：
  
  1. 国网河南省电力公司电力科学研究院
  2. 西安交通大学电力设备电气绝缘国家重点实验室
  3. 中国电力科学研究院
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2017.06.022
  CLC： TM855
- Published：2017
- 稿件说明：
移动端阅览
[1]王天,顾霄,徐阳,夏荣,邵颖彪,马德英.XLPE电缆内置传感器检测局部放电的带电校准技术研究[J].高压电器,2017,53(06):129-134+140.

WANG Tian, GU Xiao, XU Yang, et al. Online Calibration of Inner Capacitive Coupling Sensor for XLPE Cables[J]. High voltageapparatus, 2017, 53(6): 129-134+140.
[1]王天,顾霄,徐阳,夏荣,邵颖彪,马德英.XLPE电缆内置传感器检测局部放电的带电校准技术研究[J].高压电器,2017,53(06):129-134+140. DOI： 10.13296/j.1001-1609.hva.2017.06.022.

WANG Tian, GU Xiao, XU Yang, et al. Online Calibration of Inner Capacitive Coupling Sensor for XLPE Cables[J]. High voltageapparatus, 2017, 53(6): 129-134+140. DOI： 10.13296/j.1001-1609.hva.2017.06.022.

摘要

电力电缆出厂试验以及现场离线试验进行局部放电测试时

均采用以皮库（pC）表征的视在放电量来评价其绝缘水平。文中采用内置电容耦合方法进行XLPE电缆局部放电的带电检测

为了使检测结果与出厂试验等离线试验结果能够进行对比

将检测结果以视在放电电荷量形式呈现

需要提出该方法的校准方法。论文采用内置电容耦合法对基于等效电容作为分度电容的带电校准、基于频率响应的带电校准以及基于电缆等效电路仿真的带电校准等3种在线校准方法进行研究

并在实验室35 kV电缆上与IEC 60270:2000标准中规定的端部校准方法进行对比分析。实验结果显示

由于考虑了传感器与电缆金属护套间的杂散电容Cs

基于电缆等效电路仿真的内置电容耦合传感器的带电校准方法获得的校准系数准确度更高与标准端部校准有较好的吻合度。

Abstract

During factory test and off-line test in field

the apparent charge quantity is expressed in picocoulomb（p C）.A novel online calibration method based on the simulation of inner capacitive coupling equivalent circuits is proposed

to convert the measured results into the form of the quantity of the apparent charge for the comparison with the results obtained from the off-line tests.The online calibration method is performed in laboratory on a 35 kV XLPE cable along with two other online calibration methods

and compared with the terminal calibration method according to IEC 60270:2000 standard.By taking the stray capacitance Csinto consideration

the results prove that the scale factor obtained by the proposed novel method has good fit with that obtained by the standard method better.

关键词

Keywords

references

Views

297

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Application of Online Detection in Partial Discharge Test of True Switchgear

Research on Application of Microphone-optimized Spiral Arrays-based Acoustic Imaging Devices in Partial Discharge Localization

Study on Fiber Interferometric Partial Discharge Ultrasonic Sensing Method Based on Acoustic-optic Modulation and RF Phase Detection

High-frequency Sensing Technology of Partial Discharge of Switchgear Cabinet for Wind Solar & Energy Storage Stations in Gobi Deserts

Research on Influence of Piezoelectric Material Properties and Element Size on Sensitivity of Piezoelectric Sensor for Partial Discharge Monitoring of Transformer

Related Author

FAN Min

WANG Jia

HUANG Haibo

MAO Wenqi

YUE Song

GAO Fei

HAN Shuai

DONG Haoyuan

Related Institution

State Gird Hunan Electric Power Corporation Limited Research Institute

China Energy Engineering Group Co.,Ltd.,Hunan Electric Power Design Institute Corporation Limited

State Gird Hunan Electric Power Corporation Limited

Electric Power Research Institute of State Grid Tibet Company

China Electric Power Research Institute Co., Ltd.

⁰