Calculation and Study of TRV Parameters for Asymmetric Short-circuit Breaking Test（T100a） Based on Current Injection Method

ZHANG Jinbo; GAO Xiangxiang; ZHANG Yunfei; LIU Haojun; PENG Jianfei

doi:10.13296/j.1001-1609.hva.2017.07.015

您当前的位置：

首页 >

文章列表页 >

Calculation and Study of TRV Parameters for Asymmetric Short-circuit Breaking Test（T100a） Based on Current Injection Method

更新时间：2025-04-26

- Calculation and Study of TRV Parameters for Asymmetric Short-circuit Breaking Test（T100a） Based on Current Injection Method
- High VoltageApparatus Vol. 53, Issue 7, Pages: 95-99(2017)
- 作者机构：
  
  1. 西安高压电器研究院有限责任公司
  2. 国网临沂供电公司
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2017.07.015
  CLC： TM561
- Published：2017
- 稿件说明：
移动端阅览
[1]张晋波,高享想,张云飞,刘浩军,彭剑飞.基于电流注入法的非对称短路开断试验(T100a)TRV参数计算与研究[J].高压电器,2017,53(07):95-99.

ZHANG Jinbo, GAO Xiangxiang, ZHANG Yunfei, et al. Calculation and Study of TRV Parameters for Asymmetric Short-circuit Breaking Test（T100a） Based on Current Injection Method[J]. High voltageapparatus, 2017, 53(7): 95-99.
[1]张晋波,高享想,张云飞,刘浩军,彭剑飞.基于电流注入法的非对称短路开断试验(T100a)TRV参数计算与研究[J].高压电器,2017,53(07):95-99. DOI： 10.13296/j.1001-1609.hva.2017.07.015.

ZHANG Jinbo, GAO Xiangxiang, ZHANG Yunfei, et al. Calculation and Study of TRV Parameters for Asymmetric Short-circuit Breaking Test（T100a） Based on Current Injection Method[J]. High voltageapparatus, 2017, 53(7): 95-99. DOI： 10.13296/j.1001-1609.hva.2017.07.015.

摘要

高压交流断路器开断电力系统中的非对称短路故障时

由于短路电流是交流分量和直流分量的叠加

导致最后电流熄弧半波为大半波或小半波

电流过零熄弧点电源电压偏离峰值

暂态恢复电压（TRV）峰值将低于断路器开断对称短路故障情况下的数值。通过电流零点的对称短路故障（T100s）和非对称短路故障（T100a）的电流表达式

应用电流注入法原理

得出以T100s的TRV参考电压为基础

T100a的TRV参考电压的修正系数

以此来获得T100a在大、小半波开断时的TRV参考电压。研究内容为大容量试验站进行T100a试验时

评定TRV参数是否满足标准要求的范围

为试验时TRV调频装置L、R、C元件参数的调整提供了理论依据。

Abstract

When the high-voltage AC circuit-breakers breaking the asymmetrical short-circuit fault in the power system

the short-circuit current is the superposed by AC component and DC component which resulting the last current arc-extinguishing loop is major loop or minor loop. Because the current zero point deviates from peak of the power supply voltage

the TRV peak will be lower than the value of symmetrical short circuit fault breaking. Based on the principle of current injection and TRV values of T100 s

according to current expression of T100 s and T100 a

the correction coefficients of TRV values of T100 a can be calculated for major loop or minor loop. Finally

the research of this paper can help to assess the TRV parameters of T100 a test and adjust the R

C values of frequency modulation device in high power laboratory.

关键词

Keywords

references

Views

106

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Calculation of di/dt at Current Zero and TRV PeakValue u_c for Test-duty T100a

Calculation of TRV Parameters of T100a Test for Medium Voltage Circuit-breakers Based on the DC Component at Current Zero

Calculation of Short-circuit Current and Transient Recovery Voltage for Circuit-breakers Intended for Controlled Switching During T100a Test

Research of Shunt Capacitor Impact on Transient Recovery Voltage for Generator Circuit-breakers

Analysis on Short Circuit Test Program of Circuit Breaker for Large Capacity Generator

Related Author

HU Xun

LI Gang

DONG Wei

YAO Sili

HUANG Shi

YANG Wei

GAO Xiangxiang

ZHU Taiyun

Related Institution

State Grid Anhui Electric Power Researc Institute

Xi’an High Voltage Apparatus Research Institute

State Grid Anhui Electric Power Co., Ltd.

Economic & Technical Research Institute of State Grid Anhui Power Co.,Ltd.

Xi'an High Voltage Apparatus Research Institute Co, Ltd

⁰