Wave Process Simulation Analysis of 1 100 kV GIS Under Oscillation Impulse Testing Voltages

KANG Jun; LI Qiuyang; LI Yuan; QU Quanlei; LI Jiangtao; HU Mengchen; CHENG Peng; PENG Jie; WANG Yujie

doi:10.13296/j.1001-1609.hva.2018.02.004

您当前的位置：

首页 >

文章列表页 >

Wave Process Simulation Analysis of 1 100 kV GIS Under Oscillation Impulse Testing Voltages

更新时间：2025-04-26

- Wave Process Simulation Analysis of 1 100 kV GIS Under Oscillation Impulse Testing Voltages
- High VoltageApparatus Vol. 54, Issue 2, Pages: 20-25+32(2018)
- 作者机构：
  
  1. 国网青海省电力公司电力科学研究院
  2. 西安交通大学
  3. 中国电力科学研究院
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2018.02.004
  CLC： TM595
- Published：2018
- 稿件说明：
移动端阅览
[1]康钧,李秋阳,李渊,曲全磊,李江涛,胡梦晨,程鹏,彭洁,王煜杰.1100 kV GIS设备振荡冲击试验电压下的波过程仿真计算研究[J].高压电器,2018,54(02):20-25+32.

KANG Jun, LI Qiuyang, LI Yuan, et al. Wave Process Simulation Analysis of 1 100 kV GIS Under Oscillation Impulse Testing Voltages[J]. High voltageapparatus, 2018, 54(2): 20-25+32.
[1]康钧,李秋阳,李渊,曲全磊,李江涛,胡梦晨,程鹏,彭洁,王煜杰.1100 kV GIS设备振荡冲击试验电压下的波过程仿真计算研究[J].高压电器,2018,54(02):20-25+32. DOI： 10.13296/j.1001-1609.hva.2018.02.004.

KANG Jun, LI Qiuyang, LI Yuan, et al. Wave Process Simulation Analysis of 1 100 kV GIS Under Oscillation Impulse Testing Voltages[J]. High voltageapparatus, 2018, 54(2): 20-25+32. DOI： 10.13296/j.1001-1609.hva.2018.02.004.

摘要

特高压GIS设备进行现场冲击耐压试验时

GIS内部在振荡冲击电压波作用下易发生电磁波折、反射

由此产生的电压波叠加后可能会高于标准要求的试验电压值从而危及GIS设备绝缘。为有效评估振荡冲击电压下GIS设备内部的过电压水平

优化GIS现场冲击电压试验方法。利用EMTP仿真计算软件

基于现场实际试验参数对GIS正常施加冲击耐压以及GIS发生闪络两种工况下的波过程开展了仿真计算分析

得到了GIS设备各节点的电压分布。结果表明

正常情况下对GIS施加振荡型冲击电压时

GIS各节点电压幅值差异较小

一旦发生内部闪络后

在截断电压波作用下

GIS支路末端电压会远超试验电压值进而引发二次闪络。针对该现象

根据仿真计算结果提出在试验回路中加入阻尼电阻的抑制措施

并结合现场实测进行验证。通过对仿真计算及现场实测结果的对比分析

大幅减少了现场冲击耐压试验次数

有效防止现场试验时过电压对GIS设备的损害

为今后开展1 100 k V GIS设备现场冲击电压试验提供了技术依据。

Abstract

In the process of field impulse voltage withstand test of UHV GIS（gas insulated switchgear）

electromag-netic waves in GIS affected by oscillatory surge voltage are prone to refraction and reflection

and that will causes thevoltage waves superposition may higher than the test voltage required by the standard

endangering GIS insulation.To effectively evaluate the GIS overvoltage in case of oscillatory surge

the impulse voltage test method is optimized.The voltage distribution of each GIS node of is obtained by utilizing EMTP simulation software

based on field test pa-rameters

for the simulation of and analysis on the wave process in two different conditions

normal impulse with-stand voltage of GIS and flashover of GIS in the test process. The results show that GIS nodes demonstrated similarvoltage without noticeable wave process in case of normal oscillatory surge of GIS. However

in case of internal flash-over

the end node voltage of GIS branch affected by the cut-off voltage waves would greatly exceed the test voltage

triggering secondary flashover. In consideration of this case

feasible suppression measures are proposed on the basisof simulation calculation and in combination with actual conditions

which provides a technical basis for the field im-pulse voltage test of 1 100 k V GIS equipment in the future.

关键词

Keywords

references

Views

149

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Design Method and Experimental Research on Low-temperature Anti-liquefaction Measures for 1 100 kV GIS

Fault Detection and Analysis on Closing Resistor of 1 100 kV GIS Circuit Breaker

The Modeling and Simulation of the Very Fast Transients in the GIS Primary Circuits

Simulation of Temperature Field and Ampacity of Underground Cable System Based on Finite Element Method

Temperature Field Simulation of Contact Heating in High Voltage Switchgear

Related Author

YANG Xilong

TA Yuanchao

WANG Haoyu

GU Qun

MU Shuanglu

LI Xinyi

XU Peng

CHU Zhoujian

Related Institution

Xi'an Xidian Switch Electric Co, Ltd

Maintence Branch Company, State Grid Jiangsu Electric Power Co, Ltd

School of Electrical and Electronic Engineering, North China Electric Power University

School of Mechamical Engineering,North China Electric Power University

The State Key Laboratory of Power Transmission Equipment & System Security and New Technology,Chongqing University

⁰