Simulation of Space Charge Characteristics of Epoxy Resin at Different Temperatures

QIN Sichen; TU Youping; JIN Hua; CHEN Bingying; TAN Tian; WANG Cong

doi:10.13296/j.1001-1609.hva.2018.05.023

您当前的位置：

首页 >

文章列表页 >

Simulation of Space Charge Characteristics of Epoxy Resin at Different Temperatures

更新时间：2025-04-26

- Simulation of Space Charge Characteristics of Epoxy Resin at Different Temperatures
- High VoltageApparatus Vol. 54, Issue 5, Pages: 144-149+155(2018)
- 作者机构：
  
  1. 华北电力大学高电压与电磁兼容北京市重点实验室
  2. 华北电力大学新能源电力系统国家重点实验室
  3. 华北电力大学控制与计算机工程学院
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2018.05.023
  CLC： TM21
- Published：2018
- 稿件说明：
移动端阅览
[1]秦司晨,屠幼萍,金花,陈冰莹,谭天,王璁.不同温度下环氧树脂空间电荷特性仿真研究[J].高压电器,2018,54(05):144-149+155.

QIN Sichen, TU Youping, JIN Hua, et al. Simulation of Space Charge Characteristics of Epoxy Resin at Different Temperatures[J]. High voltageapparatus, 2018, 54(5): 144-149+155.
[1]秦司晨,屠幼萍,金花,陈冰莹,谭天,王璁.不同温度下环氧树脂空间电荷特性仿真研究[J].高压电器,2018,54(05):144-149+155. DOI： 10.13296/j.1001-1609.hva.2018.05.023.

QIN Sichen, TU Youping, JIN Hua, et al. Simulation of Space Charge Characteristics of Epoxy Resin at Different Temperatures[J]. High voltageapparatus, 2018, 54(5): 144-149+155. DOI： 10.13296/j.1001-1609.hva.2018.05.023.

摘要

研究直流电压下环氧树脂复合材料的电荷输运特性对推进直流气体绝缘金属封闭输电线路的发展至为重要。文中基于双极性载流子输运模型

通过对0、30、60、105℃下环氧树脂内部的空间电荷分布规律进行数值计算研究

获得了温度对环氧树脂材料内部空间电荷输运特性的影响规律

以及不同温度下环氧树脂复合材料内电场强度分布规律。结果表明:在0℃和30℃下

环氧树脂复合材料内为电子电荷主导

迁移作用使得靠近阳极附近的电场强度升高。随着温度的升高

电荷分布到达稳态所需要的时间随之减少

而电场强度最大值也随之降低。60℃和105℃下环氧树脂内电荷分布与0℃和30℃下的电荷分布呈现完全不同的趋势。高温下电荷的迁移作用和陷阱的捕获作用加强

使得电荷更为容易积聚与电极附近

从而同时削弱阳极和阴极与材料界面处的电场强度。研究成果可以为直流输电管道绝缘子的材料改性和空间电荷特性的精密调控提供理论依据。

Abstract

The study of space charge transport characteristics of epoxy resin under DC voltage is significant to thedevelopment of gas insulated transmission line（GIL）. In this paper

bipolar carrier transport model was establishedto numerical calculus the space charge distribution in epoxy resin at 0

105 ℃. The influence of temperatureon the internal space charge transport characteristics of epoxy resin

as well as the distribution of electric fieldstrength

was obtained. Results show that the electron charge is dominant in the epoxy resin material

and theelectric field near the anode is increased by the migration at the temperature of 0 ℃ and 30 ℃. With the increase ofthe temperature

the time for charge distribution to reach a new steady-state decreases. However

the chargedistribution of epoxy resin at 60 ℃ and 105 ℃ shows a completely different trend. The enhancement of chargemigration and trap’s capture makes the charge accumulate near the electrode much more easier

which reduces theelectric field strength at material interface near anode and cathode. The results can provide theoretical basis for thematerial modification of insulators in GIL and precision regulation of space charge characteristics.

关键词

Keywords

references

Views

371

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Research on Sensing and Temperature Characteristics of Chip Type Optical-Silicon-based Electric Field Sensor Based on Electro-optical Polymer Film

Effect of Degassing Time on Byproducts Content and DC Characteristics of Cable Insulation

Numerical Analysis of Electric Field in the SF₆ Pufter Circuit Breaker

Numerical Calculation of Electric Field at the Surface of the Electrodes

Pre-ionization Effect on Impulse Breakdown in a Pin-Plane Gap

Related Author

WEI Shichao

LIU Yang

LIU Jingxuan

LI Haifeng

LIANG Gang

CHEN Ning

RAO Yufei

YANG Qing

Related Institution

Henan Nuodun Technology Co., Ltd.

School of Electrical Engineering, Chongqing University

State Grid Henan Electric Power Research Institute

Chongqing Taishan Cable Co., Ltd.

State Key Laboratory of Electrical Insulation and Power Equipment, Xi’an Jiaotong University

⁰