Measurement and Analysis of Metal Fittings Electrolytic Corrosion Current and Charge of Porcelain and Glass Insulators on HVDC Transmission Lines

GUO Chenjun; YANG Daiming; MEI Hongwei; WANG Liming

doi:10.13296/j.1001-1609.hva.2018.05.036

您当前的位置：

首页 >

文章列表页 >

Measurement and Analysis of Metal Fittings Electrolytic Corrosion Current and Charge of Porcelain and Glass Insulators on HVDC Transmission Lines

更新时间：2025-04-26

- Measurement and Analysis of Metal Fittings Electrolytic Corrosion Current and Charge of Porcelain and Glass Insulators on HVDC Transmission Lines
- High VoltageApparatus Vol. 54, Issue 5, Pages: 230-235(2018)
- 作者机构：
  
  1. 云南电网有限责任公司电力科学研究院
  2. 清华大学深圳研究生院
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2018.05.036
  CLC： TM216
- Published：2018
- 稿件说明：
移动端阅览
[1]郭晨鋆,杨代铭,梅红伟,王黎明.高压直流瓷和玻璃绝缘子金具电解腐蚀电流与电荷量的测量与分析[J].高压电器,2018,54(05):230-235.

GUO Chenjun, YANG Daiming, MEI Hongwei, et al. Measurement and Analysis of Metal Fittings Electrolytic Corrosion Current and Charge of Porcelain and Glass Insulators on HVDC Transmission Lines[J]. High voltageapparatus, 2018, 54(5): 230-235.
[1]郭晨鋆,杨代铭,梅红伟,王黎明.高压直流瓷和玻璃绝缘子金具电解腐蚀电流与电荷量的测量与分析[J].高压电器,2018,54(05):230-235. DOI： 10.13296/j.1001-1609.hva.2018.05.036.

GUO Chenjun, YANG Daiming, MEI Hongwei, et al. Measurement and Analysis of Metal Fittings Electrolytic Corrosion Current and Charge of Porcelain and Glass Insulators on HVDC Transmission Lines[J]. High voltageapparatus, 2018, 54(5): 230-235. DOI： 10.13296/j.1001-1609.hva.2018.05.036.

摘要

金具电解腐蚀是高压直流输电线路上瓷和玻璃绝缘子一直存在的问题。针对用于表征腐蚀速率和发展程度的腐蚀电流与电荷量

分析了其测量原理与测量实现方法

研制了高精度宽范围的腐蚀电流测量装置并进行测量精度检验。采用盐雾法对绝缘子进行电解腐蚀试验

获得试验过程中腐蚀电流和电荷量

对数据进行了对比与统计分析。试验结果表明

绝缘子在盐雾环境中发生电解腐蚀的电流呈现波动性和随机性

绝缘子间的腐蚀电荷量呈现差异性

差异与绝缘子悬挂方式无关。此外

开发了一套腐蚀电流与电荷量在线监测系统并在±500 kV高压直流输电线路上进行安装

获得绝缘子串的腐蚀电流、电荷量、环境温度、湿度等数据。数据分析结果显示

随着相对湿度的增加

腐蚀电荷量和腐蚀电流的平均值均出现两种变化趋势

一种为明显的不断增加

另一种为先减小后增加的微弱变化。

Abstract

Electrolytic corrosion of hardware is always a problem in porcelain and glass insulators on HVDC trans-mission lines. Corrosion current and charge are for characterizing the corrosion rate and degree. The measurementprinciple and implementation method of them were analyzed. Then

a high accuracy and wide range equipment forcorrosion current measurement was developed. The electrolytic corrosion test of insulators was carried out by saltspray method

and the corrosion current and charge were obtained. The data were compared and analyzed statistical-ly. The results showed that the current during electrolytic corrosion test in salt fog presented fluctuation and disper-sion

and the corrosion charges were different among insulators. The difference is irrelevant to the mode of insulatorsuspension. In addition

an on-line monitoring system for corrosion charge was developed and installed on a ±500 kVHVDC transmission line. The corrosion current

charge

ambient temperature and humidity of the insulator stringwere obtained. Data analysis showed that with the increase of relative humidity

the average value of corrosion chargeand current had two trends

one was obviously increasing

and the other is decreasing first and then increasing.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

STUDY ON DIGITAL SIMULATION OF TRANSFERING DIRECT CURRENT USING DC BREAKERS

HVDC TEST FOR CONVERTER TRANSFORMER

A NEW SYNTHETIC TEST CIRCUIT FOR THE OPERATIONAL TEST OF HVDC THYRISTOR MODULES

MODERN HVDC THYRISTOR VALVES AND HVDC TRANSMISSION TECHNOLOGIES

Analysis of the Mismatch of HVDC Control and Protection System

Related Author

?SHANG Jin cheng

?ZHAO Bo nan

?GOU Rui feng

ZHANG Wan rong

ZHANG Chang shuan

D.Windmar

H-O Bjarme

Related Institution

Xi’an High Voltage Apparatus Research Institute

西安高压电器研究所陕西西安710077

Xi’an XD Transformer Co., Ltd.

ABB Power Systems AB ABB Switchgear AB,SE-77180Ludvika

ABBPowerSystemsABABBSwitchgearAB SE-77180Ludvika

⁰