Vibration Simulation of GIS Horizontal Bus Shell Based on FEM

QI Weidong; NIU Bo; HU Degui; WU Bang; LI Junhao; CHU Lei; LI Yafeng; FU Gang

doi:10.13296/j.1001-1609.hva.2018.06.007

您当前的位置：

首页 >

文章列表页 >

Vibration Simulation of GIS Horizontal Bus Shell Based on FEM

更新时间：2025-04-26

- Vibration Simulation of GIS Horizontal Bus Shell Based on FEM
- High VoltageApparatus Vol. 54, Issue 6, Pages: 46-52+59(2018)
- 作者机构：
  
  1. 国网陕西省电力公司电力科学研究院
  2. 西安交通大学电气工程学院
  3. 国网渭南供电公司
  4. 国网西安供电公司
  5. 国网河南省电力公司电力科学研究院
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2018.06.007
  CLC： TM595
- Published：2018
- 稿件说明：
移动端阅览
[1]齐卫东,牛博,胡德贵,吴邦,李军浩,褚磊,李亚峰,付刚.基于有限元的GIS水平母线外壳振动仿真研究[J].高压电器,2018,54(06):46-52+59.

QI Weidong, NIU Bo, HU Degui, et al. Vibration Simulation of GIS Horizontal Bus Shell Based on FEM[J]. High voltageapparatus, 2018, 54(6): 46-52+59.
[1]齐卫东,牛博,胡德贵,吴邦,李军浩,褚磊,李亚峰,付刚.基于有限元的GIS水平母线外壳振动仿真研究[J].高压电器,2018,54(06):46-52+59. DOI： 10.13296/j.1001-1609.hva.2018.06.007.

QI Weidong, NIU Bo, HU Degui, et al. Vibration Simulation of GIS Horizontal Bus Shell Based on FEM[J]. High voltageapparatus, 2018, 54(6): 46-52+59. DOI： 10.13296/j.1001-1609.hva.2018.06.007.

摘要

气体绝缘金属封闭开关设备（GIS）在运行中因电磁力导致的异常机械振动时有发生。为研究三相共体水平GIS母线外壳的受力与振动特性

使用有限元分析软件

建立三相工频电流源激励下的水平GIS母线模型

进行稳态电磁场分析

得到外壳所受电磁力

再建立金属外壳的结构动力学模型

求解电磁力激励下的外壳振动加速度响应。结果表明

金属外壳受到周期性变化的电磁力作用

频率为激励源频率的两倍。在该电磁力的作用下

外壳产生机械振动

外壳两侧中线节点的振动加速度显著大于其他位置

其变化频率与电动力频率一致。在三相共体GIS试验平台进行工频电流激励下的外壳振动加速度信号检测

通过分析外壳不同位置的信号强度与加速度频率

验证了仿真模型的准确性。

Abstract

Abnormal mechanical vibration of gas-insulated metal-enclosure switchgear（GIS）is caused occasionally by electromagnetic force. In this study

a finite element method（FEM）software was used to investigate the electromagnetic force and vibration characteristics of the three-phase-enclosed horizontal GIS bus shell. Firstly

a horizontal GIS bus model under three-phase power-frequency current excitation was established

steady electromagnetic analysis was conducted

and the electromagnetic force the shell suffered was obtained. Secondly

a structural dynamic model of the metal shell was also established to obtain the shell’s vibration acceleration response under the electromagnetic force. Results show that the shell suffers periodical electromagnetic force with the frequency twice of the excitation frequency. Under the electromagnetic force

mechanical vibration of the shell starts

and the vibration acceleration of the nodes on the mid-line of both sides of the shell is more remarkable compared with that at other locations. The vibration acceleration’s frequency is the same with that of the electromagnetic force. Experiment was conducted on a three-phase enclosed GIS platform to detect the metal shell’s vibration acceleration signal under power frequency current excitation. Analyses on the signals intensity at different locations and the vibration acceleration frequency verified the accuracy of the structural dynamic model.

关键词

Keywords

references

Views

269

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Vibration Simulation of GIS Circuit Breaker with Pneumatic Actuator

Vibration Sound Power Measurement Method of UHV Transformer Based on Location of Main Vibration Point

Research on Classification Algorithm Optimization of Transformer Vibration Eigenvalues

Study on Electromagnetic Force and Vibration Reduction Method of Large Capacity Transformer Clamp

Research on Non-invasive Multi-information Detection and Fault Diagnosis for Operating Mechanism of High Voltage Circuit Breaker

Related Author

YANG Dingge

YANG Ren

QI Weidong

ZHANG Heng

JIAN Yongfeng

YANG Bo

ZHANG Wanjun

LU Zhumao

Related Institution

State Grid Xi’an Electric Power Supply Company

Institute of Electrical Engineering Chinese Academy of Sciences

School of Electronic, Electrical and Communication Engineering University of Chinese Academy of Sciences

State Grid Shanxi Electric Power Company Electric Power Research Institute

State Grid Fujian Electric Power Research Institute

⁰