Calculation of the Voltage Distribution of Insulator Strings in 500 kV Lines Based on the Combination of Electrical Field and Road

LI Jiajing; DONG Zhen; QU Kai

doi:10.13296/j.1001-1609.hva.2018.08.004

您当前的位置：

首页 >

文章列表页 >

Calculation of the Voltage Distribution of Insulator Strings in 500 kV Lines Based on the Combination of Electrical Field and Road

更新时间：2025-04-26

- Calculation of the Voltage Distribution of Insulator Strings in 500 kV Lines Based on the Combination of Electrical Field and Road
- High VoltageApparatus Vol. 54, Issue 8, Pages: 21-26(2018)
- 作者机构：
  
  1. 武汉理工大学机电工程学院
  2. 武汉大学电气工程学院
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2018.08.004
  CLC： TM216
- Published：2018
- 稿件说明：
移动端阅览
[1]李家靖,董振,曲锴.基于场路结合法的500 kV线路绝缘子串分布电压的计算[J].高压电器,2018,54(08):21-26.

LI Jiajing, DONG Zhen, QU Kai. Calculation of the Voltage Distribution of Insulator Strings in 500 kV Lines Based on the Combination of Electrical Field and Road[J]. High voltageapparatus, 2018, 54(8): 21-26.
[1]李家靖,董振,曲锴.基于场路结合法的500 kV线路绝缘子串分布电压的计算[J].高压电器,2018,54(08):21-26. DOI： 10.13296/j.1001-1609.hva.2018.08.004.

LI Jiajing, DONG Zhen, QU Kai. Calculation of the Voltage Distribution of Insulator Strings in 500 kV Lines Based on the Combination of Electrical Field and Road[J]. High voltageapparatus, 2018, 54(8): 21-26. DOI： 10.13296/j.1001-1609.hva.2018.08.004.

摘要

高压线路绝缘子串的电压分布极不均匀并且测量难度较大。为此

提出了一种新的计算绝缘子串分布电压的方法

该方法通过Maxwell电容矩阵计算出绝缘子杂散电容

再将其代入到绝缘子串等效电路中进行计算

比传统有限元方法考虑更全面

且更加简便。通过该方法对某500 kV线路绝缘子串电压分布进行了仿真计算

通过试验验证其结果与实测一致

且比传统电路法更精确。利用此算法初步计算了500 kV线路不同位置绝缘子发生劣化对绝缘子串电压的影响

指出了目前劣化绝缘子的判定方法可能会造成漏判。

Abstract

The voltage distribution of high-voltage line insulator strings is extremely uneven and difficult to measure.This paper presents a new method for calculating the voltage distribution of insulator strings. This method calculates the insulator stray capacitance by Maxwell capacitance matrix and then substitutes it into the equivalent circuit of the insulator string for calculation. It is more comprehensive and more accurate than traditional methods. Through this method

the voltage distribution of insulator strings in a 500 kV line is simulated and the result is in good agreement with the actual measurement through experiment and it is more accurate than traditional circuit method. It is proved that the algorithm is feasible. Use this algorithm to calculate the influence of insulator deterioration at different positions of 500 kV line on the voltage of insulator strings. It is pointed out that the current method of deteriorating insulators may cause missed judgments.

关键词

Keywords

references

Views

127

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Research on Harmonic Restoration Method Based on CVT Circuit Model

SEVERAL CHARACTERISTICS OF THE QUALITATIVE FACTOR OF SERIES RESONANT CIRCUIT FOR VOLTAGE WITHSTANDING TEST ON SITE

EXPERIMENTAL ANALYSIS OF UNIDENTIFIED FLASHOVER FOR COMPOSITE INSULATORS

A CONTROL CIRCUIT DESIGN WITH ON-LINE MONITORING FUNCTION OF CAPACITOR BEHAVIOUR

Calculation of Voltage Distribution Along Composite Insulator Strings and Position Optimization of Grading Rings

Related Author

HU Guangfu

ZHU Haoshuai

HAO Liangshou

DAI Jiashui

JIANG Hai

GUO Shuyong

GUO Sen

JIANG Xiu chen

Related Institution

Laboratory of Power Transmission Equipment Technology, Chongqing University

EHV Power Transmission Company Tianshengqiao Branch, China Southern Power Grid

East China Electric Power Research & Test Institute

上海交通大学电力学院上海200030

Shanghai Jiaotong University

⁰