FEM Analysis on the Distribution of Internal Radial Potential Along ±800 kV DC Voltage Divider

WEI Xiaoxing; LIU Wanying; SUN Yong; XIA Gulin; CHU Jinwei; LU Wenhao

doi:10.13296/j.1001-1609.hva.2019.02.003

您当前的位置：

首页 >

文章列表页 >

FEM Analysis on the Distribution of Internal Radial Potential Along ±800 kV DC Voltage Divider

更新时间：2025-04-26

- FEM Analysis on the Distribution of Internal Radial Potential Along ±800 kV DC Voltage Divider
- High VoltageApparatus Vol. 55, Issue 2, Pages: 14-20+30(2019)
- 作者机构：
  
  1. 超高压输电公司检修试验中心
  2. 超高压输电公司
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2019.02.003
  CLC： TM721.1
- Published：2019
- 稿件说明：
移动端阅览
[1]韦晓星,刘婉莹,孙勇,夏谷林,楚金伟,卢文浩.±800kV直流分压器径向电位分布有限元分析[J].高压电器,2019,55(02):14-20+30.

WEI Xiaoxing, LIU Wanying, SUN Yong, et al. FEM Analysis on the Distribution of Internal Radial Potential Along ±800 kV DC Voltage Divider[J]. High voltageapparatus, 2019, 55(2): 14-20+30.
[1]韦晓星,刘婉莹,孙勇,夏谷林,楚金伟,卢文浩.±800kV直流分压器径向电位分布有限元分析[J].高压电器,2019,55(02):14-20+30. DOI： 10.13296/j.1001-1609.hva.2019.02.003.

WEI Xiaoxing, LIU Wanying, SUN Yong, et al. FEM Analysis on the Distribution of Internal Radial Potential Along ±800 kV DC Voltage Divider[J]. High voltageapparatus, 2019, 55(2): 14-20+30. DOI： 10.13296/j.1001-1609.hva.2019.02.003.

摘要

直流分压器由于内部阻容单元与外绝缘结构电压分布不同

不可避免地使阻容单元与空心绝缘子之间形成径向电位差。为研究直流分压器径向电位与大气环境条件的关系

以具有复合外套的±800 kV直流分压器为例

采用有限元分析计算干燥、均匀湿污、非均匀湿污和大雨等条件下直流分压器内部的径向电位分布。计算结果表明

干燥条件下径向电位最高处位于分压器高压端附近第二节阻容单元处

最高径向电位差约为60 kV;湿污条件下

分压器最大径向电位略微升高

约3 kV;雨量较大并桥接部分伞裙时

最大径向电位会有不同程度的提高

与雨帘的长度和位置有关。直流分压器内部径向电位的抬升易引发内部电极径向放电的风险

因此直流分压器内部绝缘裕度设计过程中应考虑不同工况下的径向电位变化。

Abstract

As the different electrical potential between internal resistance-capacitance unit and outdoor insulation

the radial potential difference between resistance-capacitance unit and Hollow insulator is inevitable.In order to find out the relationship between the internal radial potential of DC voltage divider and the surrounding environment

a FEM（Finite Element Method）analysis are carried out by the example of ±800 kV DC voltage divider with composite housing.The internal radial potential of DC voltage divider under the dry condition

uniform wet pollution

non-uniform wet pollution and heavy rain conditions are calculated.The simulation results show that the maximum radial potential of the DC divider subjected to dry condition is about 60 kV located at the second resistance-capacitance unit near the high voltage terminal.For the case of wet and polluted condition

the radial potential is about3 kV larger than that in the case of dry condition.When heavy rain and part of the sheds of the composite housing are bridged by the rain

the maximum radial potential increases

and the displacement is related to the length and location of the sheds bridged.With the increase of internal radial potential

the voltage divider will run the high risk of radial discharge.Thus then the radial potential under different environment conditions are strongly recommended to consider in the insulation design of DC voltage divider.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Analysis on HVDC Voltage Abnormal Fluctuation of Tuanlin Converter Station

Investigate on the Failure Mechanism of the DC Voltage Divider for Its Secondary Voltage Jumping Abnormally in Fulong and Fengxian Substation

Calibration Model for ±800 kV DC Divider

Test Characteristics of SF₆ Decomposition Components for Internal Fault of ±800 kV UHVDC Voltage Divider

Related Author

HU Xuebing

ZHANG Zhengmao

LEI Ming

WANG Benjin

WU Xixiu

XU Si’en

WU Shipu

QIU Jin

Related Institution

UHV AC and DC Inspection Centre,State Grid Hubei Corporation Maintenance Company

SGCC Key Laboratory of High Voltage Equipment Operating Performance Evaluation Technology,China Electric Power Research Institute

Automation School,Wuhan University of Technology

EHV Maintenance & Test Center,China Southern Power Grid Company Limited

GZ Bureau,CSG EHV Power Transmission Company

⁰