Research on Partial Discharge of ZW20 Switch After Built-in Electronic Sensor

ZHANG Wenkai; WU Xiaozhao; CUI Yu; LIU Gaofeng; WANG Kun

doi:10.13296/j.1001-1609.hva.2019.03.008

您当前的位置：

首页 >

文章列表页 >

Research on Partial Discharge of ZW20 Switch After Built-in Electronic Sensor

更新时间：2025-04-26

- Research on Partial Discharge of ZW20 Switch After Built-in Electronic Sensor
- High VoltageApparatus Vol. 55, Issue 3, Pages: 51-58(2019)
- 作者机构：
  
  1. 许继集团有限公司
  2. 许昌许继德理施尔电气有限公司
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2019.03.008
  CLC： TM855
- Published：2019
- 稿件说明：
移动端阅览
[1]张文凯,吴小钊,崔宇,刘高锋,王坤.内置电子式传感器后ZW20开关局部放电研究[J].高压电器,2019,55(03):51-58.

ZHANG Wenkai, WU Xiaozhao, CUI Yu, et al. Research on Partial Discharge of ZW20 Switch After Built-in Electronic Sensor[J]. High voltageapparatus, 2019, 55(3): 51-58.
[1]张文凯,吴小钊,崔宇,刘高锋,王坤.内置电子式传感器后ZW20开关局部放电研究[J].高压电器,2019,55(03):51-58. DOI： 10.13296/j.1001-1609.hva.2019.03.008.

ZHANG Wenkai, WU Xiaozhao, CUI Yu, et al. Research on Partial Discharge of ZW20 Switch After Built-in Electronic Sensor[J]. High voltageapparatus, 2019, 55(3): 51-58. DOI： 10.13296/j.1001-1609.hva.2019.03.008.

摘要

基于静电场分析研究ZW20型柱上开关局部放电是绝缘结构优化设计的主要手段之一。文中通过静电场分析获得其电场分布云图

通过理论分析指出:出线套管密封圈附近

电流传感器与出线套管之间及绝缘盒与出线套管之间空气域电场强度超过空气的介电强度是局部放电的关键原因。而后根据静电场复合绝缘理论

提出一种出线套管内铜棒与绝缘盒动端、静端新型的连接方式

并在其内部增设法兰屏蔽罩的优化方案。通过静电场分析可知优化后关键位置气隙电场强度明显降低

并通过试验测试进行验证

从理论及工程实际中验证了此优化方案的可行性。

Abstract

The research of ZW20 switch based on electrostatic field analysis is one of the main method for the optimi-zation design of the insulation structure. In this paper

the electric field distribution is obtained depending upon elec-trostatic field analysis. The theoretical analysis that: it is the key reason for partial discharge that the electric field strength of air domain nearby the sealing ring

between the electronic current transformer and the outlet bushing

be-tween the insulating box and the outlet bushing exceeds the dielectric strength of air. According to the theory of elec-trostatic field composite insulation

a new type of connection method between copper rod in bushing and moving end and static end of insulating box is proposed

and an optimum scheme of flange shielding cover is added in bushing. It is concluded that the electric field strength of the air gap in the key position decreases obviously after optimization

and it is verified by test

the feasibility of the optimization measures in theory and engineering can be confirmed.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Research on Application of Microphone-optimized Spiral Arrays-based Acoustic Imaging Devices in Partial Discharge Localization

Study on Fiber Interferometric Partial Discharge Ultrasonic Sensing Method Based on Acoustic-optic Modulation and RF Phase Detection

High-frequency Sensing Technology of Partial Discharge of Switchgear Cabinet for Wind Solar & Energy Storage Stations in Gobi Deserts

Research on Influence of Piezoelectric Material Properties and Element Size on Sensitivity of Piezoelectric Sensor for Partial Discharge Monitoring of Transformer

Influence of Environmental Factors on Insulation Performance of Separable Connector for 12 kV Gas Filling Switchgear Cabinet

Related Author

YUE Song

GAO Fei

HAN Shuai

DONG Haoyuan

LI Jun

LI Xin

LIU Chao

QIAO Hui

Related Institution

Electric Power Research Institute of State Grid Tibet Company

China Electric Power Research Institute Co., Ltd.

Iflytek Co., Ltd.

Electric Power Research Institute, State Grid Hebei Electric Power Co., Ltd.

State Key Laboratory of Alternate Electrical Power System with Renewable Energy Sources, North China Electric Power University

⁰