Test Characteristics of SF<sub>6</sub> Decomposition Components for Internal Fault of ±800 kV UHVDC Voltage Divider

XIE Chao; SHANG Tao; LI Qiankun

doi:10.13296/j.1001-1609.hva.2019.05.036

您当前的位置：

首页 >

文章列表页 >

Test Characteristics of SF₆ Decomposition Components for Internal Fault of ±800 kV UHVDC Voltage Divider

更新时间：2025-04-26

- Test Characteristics of SF₆ Decomposition Components for Internal Fault of ±800 kV UHVDC Voltage Divider
- High VoltageApparatus Vol. 55, Issue 5, Pages: 230-233(2019)
- 作者机构：
  
  中国南方电网超高压输电公司广州局
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2019.05.036
  CLC： TM213;TM721.1
- Published：2019
- 稿件说明：
移动端阅览
[1]谢超,尚涛,李乾坤.±800 kV特高压直流分压器内部故障的SF_6分解物测试特性[J].高压电器,2019,55(05):230-233.

XIE Chao, SHANG Tao, LI Qiankun. Test Characteristics of SF₆ Decomposition Components for Internal Fault of ±800 kV UHVDC Voltage Divider[J]. High voltageapparatus, 2019, 55(5): 230-233.
[1]谢超,尚涛,李乾坤.±800 kV特高压直流分压器内部故障的SF_6分解物测试特性[J].高压电器,2019,55(05):230-233. DOI： 10.13296/j.1001-1609.hva.2019.05.036.

XIE Chao, SHANG Tao, LI Qiankun. Test Characteristics of SF₆ Decomposition Components for Internal Fault of ±800 kV UHVDC Voltage Divider[J]. High voltageapparatus, 2019, 55(5): 230-233. DOI： 10.13296/j.1001-1609.hva.2019.05.036.

摘要

分解物测试是判断SF

绝缘设备内部放电故障有效的方法。笔者在对一起直流分压器故障的分析过程中发现

气体分析未能正确反映第一次跳闸时内部已经出现的放电故障。后对直流分压器进行解体发现

由于其内部电容器气室为单独密封设计

造成电容器内部放电故障产生的SF

分解物未能在直流分压器取气口测出

以致不能正确判断设备健康状况。文中建议进行SF

分解物测试必须清楚了解设备内部气路构成

并对在运的直流分压器故障诊断提出方案

对制造厂在直流分压器内部设计提出改进建议。

Abstract

decomposition components test is an effective method to determine the internal discharge fault of SF

insulation equipment. This paper proposes that the SF

gas analysis failed to correctly reflect the discharge fault during the first trip in the analysis of the fault of DC voltage divider. After the disintegration of the DC voltage divider

it is found that the SF

decomposition generated in the capacitor internal discharge could not be detected through the gas test tap of DC voltage divide due to internal condenser gas chamber for individual seal design

and it leads to failure to correctly judge the heal

th status of the device. It is suggested that the SF

decomposition components test must be made to understand the internal gas path composition of the equipment

and the scheme of fault diagnosis of DC voltage divider in operation. Improvement suggestions are put forward for the internal design of the DC voltage divider.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Multi-signal Joint Identification and Intelligent Diagnosis of High Voltage Circuit Breaker Faults Based on VMD-BiLSTM

Design of a Digital Twin-oriented Integrated Monitoring System for Substation Switchgear

Fault Diagnosis of High Voltage Disconnector Based on Attitude Angle and Speed Curves

Fault Diagnosis Method of Generator Based on Stacked Denoising Autoencoder Network and Multi-source Data Weighted Fusion

Voiceprint Recognition Method for Mechanical Faults of 10 kV Circuit Breaker Based on Fusion Feature Residual Neural Network

Related Author

ZHANG Jinbo

ZHANG Zhaowei

WU Jianwen

SHAO Yang

LIANG Chuantao

SHEN Xiaosong

HU Dazheng

ZHANG Yiming

Related Institution

Xi’an High Voltage Apparatus Research Institute Co., Ltd.

School of Automation Science and Electrical Engineering, Beihang University

Shandong Taikai High Voltage Switchgear Co., Ltd.

Pinggao Group Co., Ltd.

Henan Pinggao Electric Co., Ltd.

⁰

Test Characteristics of SF6 Decomposition Components for Internal Fault of ±800 kV UHVDC Voltage Divider

DOI：10.13296/j.1001-1609.hva.2019.05.036

摘要

Abstract

关键词

Keywords

references

Test Characteristics of SF₆ Decomposition Components for Internal Fault of ±800 kV UHVDC Voltage Divider