Cause Analysis on Subsynchronous Oscillation in Large-scale Doubly-fed Wind Farm

DENG Wangbo; WANG Haiyun; CHANG Xiqiang; GUO Xiaolong

doi:10.13296/j.1001-1609.hva.2019.09.029

您当前的位置：

首页 >

文章列表页 >

Cause Analysis on Subsynchronous Oscillation in Large-scale Doubly-fed Wind Farm

更新时间：2025-04-26

- Cause Analysis on Subsynchronous Oscillation in Large-scale Doubly-fed Wind Farm
- High VoltageApparatus Vol. 55, Issue 9, Pages: 215-221(2019)
- 作者机构：
  
  1. 新疆大学电气工程学院
  2. 国网陕西省电力公司检修公司
  3. 新疆省电力调度控制中心
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2019.09.029
  CLC： TM614;TM712
- Published：2019
- 稿件说明：
移动端阅览
[1]邓王博,王海云,常喜强,郭小龙.大规模双馈风电场次同步振荡的成因分析[J].高压电器,2019,55(09):215-221.

DENG Wangbo, WANG Haiyun, CHANG Xiqiang, et al. Cause Analysis on Subsynchronous Oscillation in Large-scale Doubly-fed Wind Farm[J]. High voltageapparatus, 2019, 55(9): 215-221.
[1]邓王博,王海云,常喜强,郭小龙.大规模双馈风电场次同步振荡的成因分析[J].高压电器,2019,55(09):215-221. DOI： 10.13296/j.1001-1609.hva.2019.09.029.

DENG Wangbo, WANG Haiyun, CHANG Xiqiang, et al. Cause Analysis on Subsynchronous Oscillation in Large-scale Doubly-fed Wind Farm[J]. High voltageapparatus, 2019, 55(9): 215-221. DOI： 10.13296/j.1001-1609.hva.2019.09.029.

摘要

为了探究大规模双馈风电场在无串补情况下发生次同步振荡现象的原因

文中在MATLAB/SIMLINK软件搭建了双馈风机无串补线路并网模型

结合时域仿真法研究了风机出力、RSC控制器参数、无功外环控制器参数和传输线路长度与次同步振荡的关系。结果表明:风速越大

并网台数越多

即风机出力越大

则更易发生次同步振荡。单独改变RSC内环电流控制器的Ki参数

不会产生系统振荡

然而调节Kp参数太大

系统更易发生次同步振荡。外环无功控制器比例系数Kp过大

控制器参数过于灵敏

会造成无功功率的超调

系统更易发生次同步振荡。传输线路的大小只影响电压波动的范围

不会造成系统发生次同步振荡。

Abstract

To explore the reason why subsynchronous oscillation occursinlarge-scale doubly-fed wind farm without series compensation

the software MATLAB/Simulink is employed to build a grid model of doublely-fed wind turbinewith series compensation.The relations of the subsynchronous oscillation with the wind turbine output

the parameters of RSC controller and outer-loop reactive powercontroller

and the length of transmission line are investigatedbased on the time-domain simulation method.The results show that with the increase in the wind speed and turbine number in grid

the wind turbine output becomes larger

hence the subsynchronous oscillation is prone to occur.Only changing theof the RSC inner-loop current controller does not result in system oscillation

but if theis too large

the subsynchronous oscillation may happen more likely.If theproportional coefficient Kpof the outer-loop reactive power controller is too large or the parameters of the controller are too sensitive

the reactive power would be overshot and subsynchronous oscillation would happen more easily.The size of the transmission line only affects the range of voltage fluctuation

but will not cause the system’ ssubsynchronous oscillation.

关键词

Keywords

references

Views

257

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Calculation and Analysis of SVC Network Transient Performances

STUDY ON THE REGULATION STRATEGY OF SHENGSI HVDC TRANSMISSION SYSTEM

Operation Analysis of Xing-An HVDC Low Load Reactive Power Optimization Function

Research on Fault Ride Through for Wind Power System in the Terminal of the Power Grid System

DC Bias Calculation and Characteristics Analysis of Reactive Power for the UHV Transformer

Related Author

王晓林

尹克宁

GOU Rui feng

SHANGJin cheng

ZHU Jing

LIN Zhiming

YANG Mingquan

TONG Kai

Related Institution

西安交通大学 710049

西安交通大学

西安高压电器研究所陕西西安710077

Xi’an High Voltage Apparatus Research Institute

CSG EHV Transmission Companies Tianshengqiao Bureau

⁰