Optimal Instant for Controlled Switching of the Serially Compensated Transmission Lines Based on Prony Algorithm

FANG Chun’en; LI Yuhao; CHEN Chuanjiang; CHENG Xueli; LI Wei; REN Xiao

doi:10.13296/j.1001-1609.hva.2019.12.003

您当前的位置：

首页 >

文章列表页 >

Optimal Instant for Controlled Switching of the Serially Compensated Transmission Lines Based on Prony Algorithm

更新时间：2025-04-26

- Optimal Instant for Controlled Switching of the Serially Compensated Transmission Lines Based on Prony Algorithm
- High VoltageApparatus Vol. 55, Issue 12, Pages: 15-22(2019)
- 作者机构：
  
  1. 西华大学
  2. 四川省电力电子节能技术与装备重点实验室
  3. 四川省机场集团有限公司
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2019.12.003
  CLC： TM712
- Published：2019
- 稿件说明：
移动端阅览
[1]方春恩,李煜昊,陈川江,程雪丽,李伟,任晓.基于Prony算法的串补空载线路选相关合最佳合闸时刻研究[J].高压电器,2019,55(12):15-22.

FANG Chun’en, LI Yuhao, CHEN Chuanjiang, et al. Optimal Instant for Controlled Switching of the Serially Compensated Transmission Lines Based on Prony Algorithm[J]. High voltageapparatus, 2019, 55(12): 15-22.
[1]方春恩,李煜昊,陈川江,程雪丽,李伟,任晓.基于Prony算法的串补空载线路选相关合最佳合闸时刻研究[J].高压电器,2019,55(12):15-22. DOI： 10.13296/j.1001-1609.hva.2019.12.003.

FANG Chun’en, LI Yuhao, CHEN Chuanjiang, et al. Optimal Instant for Controlled Switching of the Serially Compensated Transmission Lines Based on Prony Algorithm[J]. High voltageapparatus, 2019, 55(12): 15-22. DOI： 10.13296/j.1001-1609.hva.2019.12.003.

摘要

为提高系统的稳定运行水平

会在大容量、远距离的电力系统中加装串补装置

但加装串补装置会破坏线路均匀性

使线路上出现严重操作过电压

严重危害电力设备的绝缘。文中根据空载线路过电压产生的基本原理

采用选相关合技术抑制串补输电线路过电压。首先研究了过电压幅值与合闸相位的关系

给出了串补输电线路选相关合策略;其次提出利用Prony算法预测电压过零点

确定最佳合闸时刻;在PSCAD和MATLAB软件中搭建串补输电线路重合闸模型

对暂态过程进行了仿真

仿真结果验证了Prony算法的准确性和可行性

同时表明了选相关合串补输电线路能大大减小合闸过电压;最后分析了断路器合闸过程中绝缘衰减率RDDS和合闸时间分散性对合闸时刻的影响

得出不同关合特性下的最佳合闸时刻。

Abstract

The series compensation device

which is added in the power system with large capacity and long distance

will weaken the line’s uniformity

lead to switching over-voltage on the line

and harm the insulation of electrical equipment.This study uses the controlled switching techniques to suppress the over-voltage of series compensation line according to the basic principle of generating over-voltage on no-load lines.The Prony algorithm is employed to predict the voltage crossing zero and determine the optimal closing instant.Reclosing models of the serially compensated transmission lines are built with the softwares PSCAD and MATLAB to simulate the transient process.The results verify the accuracy and feasibility of the Prony algorithm

and show that the controlled switching can effectively reduce the over-voltage of the serially compensated transmission line.In addition

the influences of the circuit breaker’s RDDS and the dispersity of closing times on the optimal closing instant is analyzed to obtain the optimal closing instants under different closing characteristics.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

INVESTIGATION ON SYNCHRONIZED-CLOSING CAPACITOR BANKS WITH PHASE-CONTROL VACUUM CIRCUIT BREAKER

Lightning Over-voltage Protection for 500 kV GIS Substation

Calculation and Analysis of a Switchgear Fault Caused by Lightning Strike on 220kV Transmission Lines

Study on Neutral Point Grounding Method with Low Reactant for Main Transformers in Xi′an Power Grid

Research on Elimination of No-load Power Transformers Inrush Currents Based on Controlled Switching

Related Author

ZHENG An-kang 3

GU Pi-ji 2

ZOU Ji-yan 1

DUAN Xiong-ying 1

LI Jing-lu

LI Lei

GAN Ling-xia

高媛

Related Institution

浙江宁波315101

陕西宝鸡721006

Ningbo Weilong Switchgear Company

Baoguang Electronic Group

Dalian University of Technology

⁰