Research Progress of GIS Equipment Heating

HUANG Mengdan; XIAO Chun; YANG Zhining; PANG Wenlong; WU Xixiu

doi:10.13296/j.1001-1609.hva.2020.12.004

您当前的位置：

首页 >

文章列表页 >

Research Progress of GIS Equipment Heating

更新时间：2025-04-26

- Research Progress of GIS Equipment Heating
- High VoltageApparatus Vol. 56, Issue 12, Pages: 24-33(2020)
- 作者机构：
  
  武汉理工大学自动化学院
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2020.12.004
  CLC： TM595
- Published：2020
- 稿件说明：
移动端阅览
[1]黄孟丹,肖纯,杨芷宁,庞文龙,吴细秀.GIS设备发热研究进展[J].高压电器,2020,56(12):24-33.

HUANG Mengdan, XIAO Chun, YANG Zhining, et al. Research Progress of GIS Equipment Heating[J]. High voltageapparatus, 2020, 56(12): 24-33.
[1]黄孟丹,肖纯,杨芷宁,庞文龙,吴细秀.GIS设备发热研究进展[J].高压电器,2020,56(12):24-33. DOI： 10.13296/j.1001-1609.hva.2020.12.004.

HUANG Mengdan, XIAO Chun, YANG Zhining, et al. Research Progress of GIS Equipment Heating[J]. High voltageapparatus, 2020, 56(12): 24-33. DOI： 10.13296/j.1001-1609.hva.2020.12.004.

摘要

气体绝缘金属封闭开关设备（GIS）

由于其封闭特性

内部故障难以及时检测。对GIS设备的故障进行分析

发现GIS的发热问题突出

常造成设备烧毁甚至系统停电。通过分析GIS设备的发热现状

发热理论研究和发热检测方式

研究GIS设备的发热进展。结果表明要使温升计算精确有效

需要考虑多场耦合

且考虑因素应与计算复杂度、时效性相结合。在GIS设备发热机理的基础上

简述了GIS设备的各发热故障检测方法

如回路电阻法、红外测温法和光纤光栅测温

并进行对比分析

得到各方法的优缺点。通过讨论GIS设备发热的研究现状及不足

指出了发展趋势

为进一步研究GIS设备发热情况提供一定的指导。

Abstract

It’ s difficult to detect the internal faults of gas insulated switchgear（GIS）in time because of its enclosed characteristics.By analyzing the fault of GIS

it ’ s found that the heating problem of GIS is prominent

which often causes the burning of equipment and even the system power failure.By analyzing the heating status

the theoretical studies of heating mechanism and heating detection methods of GIS

the heating progress of GIS was studied.The results show that in order to make the temperature rise calculation accurate and effective

it is necessary to consider the multi-field coupling

which should be combined with the computational complexity and timeliness.On the basis of the heating mechanism of GIS

the detection methods of various heating faults of GIS equipment

such as loop resistance method

infrared temperature measurement method and fiber bragg grating temperature measurement method

are briefly described

and the advantages and disadvantages of each method are compared and analyzed.By discussing the research status and shortcomings of GIS equipment heating

this paper points out the development trend

and provides some guidance for further research on GIS heating.

关键词

Keywords

references

Views

169

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Study on Temperature Effect of Installation Process of GIS Based on Birth and Death Element Method

Research on Enclosure Overheat Mechanism and Improvement Measures of 330 kV GIS

Analysis of Typical Fault Caused by Insulation Breakdown of 500 kV GIS Disconnector

Related Author

WU Huiying

WANG Xing

PING Chang

CAI Jianguo

WANG Shijun

WANG Lili

WU Duiping

CHEN Yao

Related Institution

State Grid Gansu Electric Power Corporation

School of Civil Engineering, Southeast University

State Grid Qinghai Electric Power Research Institute

State Grid Qinghai Electric Power Company

State Grid Corporation of China

⁰