Development and Application of 2D Coupled Electromagnetic Field-circuit Simulation Software

ZHU Sa; SHI Bin; ZHOU Wenliang; LU Chunfeng; SUN Jinchao; JIANG Wei

doi:10.13296/j.1001-1609.hva.2021.04.019

您当前的位置：

首页 >

文章列表页 >

Development and Application of 2D Coupled Electromagnetic Field-circuit Simulation Software

更新时间：2025-04-26

- Development and Application of 2D Coupled Electromagnetic Field-circuit Simulation Software
- High VoltageApparatus Vol. 57, Issue 4, Pages: 125-133(2021)
- 作者机构：
  
  1. 河海大学能源与电气学院
  2. 南京南瑞继保电气有限公司
  3. 国网江苏省电力有限公司南通供电分公司
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2021.04.019
  CLC： O441.4;TP391.7
- Published：2021
- 稿件说明：
移动端阅览
[1]朱洒,施斌,周文亮,陆春锋,孙金超,蒋伟.二维电磁场—路耦合仿真软件的开发与应用[J].高压电器,2021,57(04):125-133.

ZHU Sa, SHI Bin, ZHOU Wenliang, et al. Development and Application of 2D Coupled Electromagnetic Field-circuit Simulation Software[J]. High voltageapparatus, 2021, 57(4): 125-133.
[1]朱洒,施斌,周文亮,陆春锋,孙金超,蒋伟.二维电磁场—路耦合仿真软件的开发与应用[J].高压电器,2021,57(04):125-133. DOI： 10.13296/j.1001-1609.hva.2021.04.019.

ZHU Sa, SHI Bin, ZHOU Wenliang, et al. Development and Application of 2D Coupled Electromagnetic Field-circuit Simulation Software[J]. High voltageapparatus, 2021, 57(4): 125-133. DOI： 10.13296/j.1001-1609.hva.2021.04.019.

摘要

文中详述了一种二维瞬态电磁场与任意拓扑电路耦合仿真的原理及相应仿真软件的开发过程。根据直接耦合的思想

电路中的每个部件都视作一个有限元单元

而电路区域与电磁场区域通过细导线单元或粗导体单元联系起来

可实现任意拓扑电路与二维瞬态电磁场的耦合计算。文中详述了每种类型单元的单元方程的推导过程

并给出了单元刚度、质量和载荷矩阵的具体形式。为验证所开发软件的正确性

将其应用于一台7.5 kW永磁电机空载、正弦电流激励及PWM电压激励下的特性仿真

并与实测值进行了对比

验证了所开发软件的正确性。此外

通过对比正弦电流激励下和PWM电压激励下的计算损耗与实测值

证明了在永磁电机损耗计算中考虑PWM谐波电压影响的重要性。

Abstract

In this paper

the principle of coupled simulation for a kind of 2D transient electromagnetic filed with any topological circuit and the development process of corresponding simulation software are described in detail.According to the idea of direct coupling

each element in the electric circuit is deemed as a finite element（FE）.However

the circuit region and the FE region are connected with either filamentary wire unit or solid conductor unit to achieve the coupling calculation between any topological circuit and the 2D transient electromagnetic filed.The derivation progress of element equation of each type of unit is described in detail and the specific form of the stiffness

mass and load matrix of the unit is given.For the purpose of verifying the correctness of the developed software

it is used for the characteristic simulation of a set of 7.5 kW permanent motor at no load

sinusoidal current excitation and pulsewidth modulation（PWM）voltage excitation.The correctness of the developed software is verified by the comparison with the actually measured value.Moreover

the importance of considering the influence of PWM harmonic voltage in the loss calculation of the permanent motor is proved by comparing the calculated and the actually measured loss at sinusoidal current and PWM voltage excitation.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Research on Temperature Distribution Characteristic of Transformer Based on Finite Element Method

Optimization Design on Spring Contact Finger Structure Based on Finite Element Method and Neural Network Method

Operation Characteristic Analysis of Permanent Electromagnet for Spring Mechanism

Simulation Study on Influence of Temperature on Interface Stress of Cable Terminal

Research and Discussion on Simulation Experiment of Electromagnetic Field of High-frequency Magnetic Component

Related Author

XIE Zhibiao

WANG Chen

CHEN Liangyuan

HUANG Pei

HE Shijian

ZHOU Song

SU Juntian

DAN Shuheng

Related Institution

Hechi Power Supply Bureau of Guangxi Power Grid Co., Ltd.

Electric Power Science Research Institute of Guangxi Power Grid Co., Ltd.

College of Electrical Engineering, Shanghai University of Electric Power

School of Electrical Engineering and Automation, Xiamen University of Technology

Xiamen Key Laboratory of Frontier Electric Power Equipment and Intelligent Control

⁰