Loss and Temperature Rise Test and Analysis on 500 kV Single-phase Auto-transformer Under No-load DC Bias

LI Mingyang; ZHANG Junshuang; WANG Zezhong; LI Haiming; CHEN Yongwei

doi:10.13296/j.1001-1609.hva.2021.06.018

您当前的位置：

首页 >

文章列表页 >

Loss and Temperature Rise Test and Analysis on 500 kV Single-phase Auto-transformer Under No-load DC Bias

更新时间：2025-04-26

- Loss and Temperature Rise Test and Analysis on 500 kV Single-phase Auto-transformer Under No-load DC Bias
- High VoltageApparatus Vol. 57, Issue 6, Pages: 132-139(2021)
- 作者机构：
  
  1. 华北电力大学高电压与电磁兼容北京市重点实验室
  2. 国网内蒙古东部电力有限公司
  3. 特变电工股份有限公司新疆变压器厂
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2021.06.018
  CLC： TM411.3
- Published：2021
- 稿件说明：
移动端阅览
LI Mingyang, ZHANG Junshuang, WANG Zezhong, et al. Loss and Temperature Rise Test and Analysis on 500 kV Single-phase Auto-transformer Under No-load DC Bias[J]. High voltageapparatus, 2021, 57(6): 132-139.
DOI：

LI Mingyang, ZHANG Junshuang, WANG Zezhong, et al. Loss and Temperature Rise Test and Analysis on 500 kV Single-phase Auto-transformer Under No-load DC Bias[J]. High voltageapparatus, 2021, 57(6): 132-139. DOI： 10.13296/j.1001-1609.hva.2021.06.018.

摘要

为了分析直流偏磁对即将投入运行的某500 kV单相自耦电力变压器的损耗和热点温升的影响

在该单相变压器产品上

在出厂试验后对其进行了直流偏磁试验。在高压侧并联的模拟空载试验条件下

高压直流回路的直流电流最大加到了3.3 A;详细分析了试验测得的电压、电流、谐波、无功、空载损耗随直流电流增大的变化规律。在直流偏磁电流为2 A的模拟空载试验下

测量了铁心热点温度的变化规律。基于场路耦合模型

对比分析了电压源波形对仿真结果的影响。文中研究方法和结论对大容量电力变压器耐受直流偏磁能力的研究具有一定的参考价值。

Abstract

For analyzing the influence of DC bias on the loss and hot spot temperature rise of a 500 kV single-phase auto-transformer to be put into operation

the DC bias test is carried out on this single-phase transformer product after the delivery test. Under the simulated no-load test condition with high voltage side in parallel

the maximum DC current of 3.3 A in the high voltage circuit is applied. The variation law of the voltage

current

harmonic

reactive power and no-load loss measured by the test with the increase of DC current is analyzed in detail. In the simulated no-load test with the DC bias current of 2 A

the variation law of the core hot spot temperature is measured. Based on the fieldcircuit coupling model

the influence of voltage source waveform on simulation results is compared and analyzed.The study method and conclusion in this paper have certain reference value for the study of DC bias ability of large capacity power transformer.

关键词

Keywords

references

Views

110

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Temperature Rise Calculation and Test of Large Capacity Dry-type Air-core Reactor Under AC and DC Superimposed Current

Research on Thermal Stability Performance of Power Capacitor Under Power Frequency and Harmonic Condition

Study on contact characteristics and melting mechanism of inclined coil spring contact

The Discussion on the Steady Temperature Rise Test of SF₆ Circuit Breaker

Calculation and Analysis of SVC Network Transient Performances

Related Author

SUN Guohua

ZHANG Meng

XI Jingliang

LIU Chengzhu

XIA Zhihui

LIU Xuefeng

GUO Jiang

FENG Chunlin

Related Institution

Beijing Power Equipment Group Co, Ltd

Electric Power Research Institute of State Grid Shandong Electric Power Company

State Grid Co., Ltd.

State Key Laboratory of Power Grid Environment Protection, China Electric Power Research Institute

Guilin Power Capacitor Co., Ltd.

⁰