FAN Yangwen, LI Jun, YAO Ning, et al. Structural Design of Hybrid DC Breaker in 10 kV DC Distribution Network[J]. High voltageapparatus, 2021, 57(7): 53-59.
DOI:
FAN Yangwen, LI Jun, YAO Ning, et al. Structural Design of Hybrid DC Breaker in 10 kV DC Distribution Network[J]. High voltageapparatus, 2021, 57(7): 53-59. DOI: 10.13296/j.1001-1609.hva.2021.07.008.
Structural Design of Hybrid DC Breaker in 10 kV DC Distribution Network
based on the requirement of pilot project of 10 kV DC distribution network and the diode rectifier hybrid topological structure
presents firstly the overall layout structure of the DC circuit breaker.Then the modular design solution of valve group is proposed and the design selection process of each module is described.The cooling system for main branch and IGBT silicon stack structure are designed on the basis of theoretical calculation and simulation analysis.As a result
the hybrid DC circuit breaker with rated voltage at 10 kV
rated current at 1 kA
maximum breaking current at 10 kA and breaking time less than 3 ms is developed.Finally
the test result shows both application feasibility and effectiveness of this type of DC circuit breaker in 10 kV distribution network.
Research on Interruption Characteristics of Low Voltage Hybrid DC Circuit Breaker
Research and Development of Lightweight 126 kV Gas Insulated Switchgear
Efficiency Optimization Analysis of 110 kV Double-break Fast Switch
Research on Interruption Process Simulation of Hybrid DC Circuit Breaker Based on Two-level Voltage Source Synthetic Test Method
Research on Influence of Key Parameters in Hybrid DC Circuit Breakers on Arc Current Commutation Characteristics
Related Author
XIONG Dezhi
CHEN Shidong
LANG Xiaojian
XIAO Yu
YIN Jianning
KANG Liutao
ZHAO Ping
HUANG Kunpeng
Related Institution
School of Electrical Engineering, Xi'an University of Technology
State Grid Hunan Electric Power Limited Company
Hunan Province Key Laboratory of Intelligent Electrical Measurement and Application Technology, Grid Hunan Electric Power Limited Company Power Supply Service Center (Metrology Center)