Online Detection Method on Winding Deformation of Transformer Based on Improved ΔU-I Locus Method

LI Zhenhua; JIANG Weihui; ZHENG Yangang; LI Zhenxing; XU Yanchun

doi:10.13296/j.1001-1609.hva.2021.08.020

您当前的位置：

首页 >

文章列表页 >

Online Detection Method on Winding Deformation of Transformer Based on Improved ΔU-I Locus Method

更新时间：2025-04-26

- Online Detection Method on Winding Deformation of Transformer Based on Improved ΔU-I Locus Method
- High VoltageApparatus Vol. 57, Issue 8, Pages: 142-150(2021)
- 作者机构：
  
  1. 三峡大学电气与新能源学院
  2. 三峡大学梯级水电站运行与控制湖北省重点实验室
  3. 国网重庆璧山供电公司
- 作者简介：
- 基金信息：
- DOI：10.13296/j.1001-1609.hva.2021.08.020
  CLC： TM41
- Published：2021
- 稿件说明：
移动端阅览
LI Zhenhua, JIANG Weihui, ZHENG Yangang, et al. Online Detection Method on Winding Deformation of Transformer Based on Improved ΔU-I Locus Method[J]. High voltageapparatus, 2021, 57(8): 142-150.
DOI：

LI Zhenhua, JIANG Weihui, ZHENG Yangang, et al. Online Detection Method on Winding Deformation of Transformer Based on Improved ΔU-I Locus Method[J]. High voltageapparatus, 2021, 57(8): 142-150. DOI： 10.13296/j.1001-1609.hva.2021.08.020.

摘要

绕组变形是电力变压器最容易发生的故障之一

未及时检测到的绕组变形增加了变压器发生灾难性事故可能性。为了准确灵敏地检测出任何轻微的绕组变形

在原有ΔU-I轨迹法的基础上提出了改进方法。文中首先阐述了原有方法的原理

并通过仿真说明了其在应用中所存在的缺陷。基于原有方法的不足

提出了负载标准化方法

解决了原方法在实际应用中受负载影响较大的问题;在此基础上

进一步提出了改进方法

并探究了测量误差对原方法和改进方法的影响情况。仿真结果表明

与原方法相比

改进方法在反映轻微绕组变形时具有更高的准确度和灵敏性。

Abstract

Winding deformation is one of the most common faults in power transformers.The winding deformation which has not been detected in time increases the possibility of catastrophic accidents of transformer.In order to detect any slight winding deformation accurately and sensitively

an improved method is proposed on the basis of the original ΔU-I locus method.The principle of the original method is described firstly.The defect of it in the application is illustrated by simulation.Based on the shortcomings of the original method

the load standardization method is proposed

which solves the problem of the original method with big load influence in practical application and

on this basis

the modification method is proposed further.The influence of the measurement error on the original and the improved method is also discussed.The simulation results show that the improved method

compared to the original method

has higher accuracy and sensitivity in reflecting slight winding deformation.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Quality Detection，Diagnosis and Testing of Power Transformer Based on Chaotic Algorithm

Study on Electromagnetic Force and Vibration Reduction Method of Large Capacity Transformer Clamp

Study on Diagnosis Method of Power Transformer Winding Deformation Based on Signal Distance Degree Model and SVM

Research on Cross-interference and Calibration Method for Photoacoustic Spectroscopic Detection of SF₆ Decomposition Gas

Research on Insulation State Assessment Method of Power Transformer Based on Health Index

Related Author

TIAN Lin

ZHANG Da

LIU Zhen

WU Hongbo

YAN Jing

WEN Jun

CONG Haoxi

YANG Huina

Related Institution

State Grid Hebei Electric Power Co., Ltd.

State Grid Hebei Marketing Service Center

Wuhan University

North China Electric Power University

College of Electrical Engineering and New Energy, China Three Gorges University

⁰